I have a Telxon PTC-710. We are getting an error code 68> . We use it to scan library barcodes for inventory. How can we reset/get back to our main menu? We would be grateful for any help/advice.

http://www.texon.com/contact-us
USA Sales and Customer Service
Contacts:
Phil Bouldin - Group Sales Director
Tel: +1 978 239 9473
Ben Soto - Global Accounts Manager
Mobile: +1 801 330 6519
Tom Muller - Global Accounts Manager, East Coast
Tel: +1 914 474 9294
Roy Hill - Global Accounts Manager, West Coast
Tel: +1 503 957 3377
Sue Mitchell - Customer Care Manger
Tel: +1 413 862 3652

Contact Us

You have no arc chip below the os chip or the ptc is not seeing it.

These old Telxon devices had a switch in the battery compartment to disable the backup battery for storage, power off the unit then change the switches position and try again.

If you still have the problem the unit will need a new backup battery fitting. The unit will need to be opened and a new cell soldered onto the mainboard.

If you really get stuck contact:

www.portablesolutions.com

Hold the 5 key down for three beeps. This should clear the memory and return you to your software application.

It might depend on your application, but I'd try downloading all the information you scanned more often than every 20K items. It's possible that you are filling up the memory in the unit and it won't accept any more.

with the unit off, hold down the two keys on the bottom corner (enter, sp key) and press then release the on key while continuing to hold down the "enter" and "sp" keys until you get a promt on the display.
When a prompt comes up release all the keys. Hold down the 5 key for 3 beeps. The unit will test memory for about 1 min, then beep. Press any key to turn the device off. Then press the on key to power the unit back up.

if you need additional information please let me know.

Kim Ganoe - 800.933.2839 x251

We have all manuals and sofware for this Telxon device. You can always contact me directly [email protected] or 630-622-2024 toll free 866-271-9891 Ask for Andrew

Hello swschmidt. You are spot-on! You need to do a wee bit of configuration. I host he LS2208 manual on my company site for my clients (www.shiftintoblue.com/resources/ls2208_manual.pdf). Head to page 146: "Wand Emulation Host Parameters". Print that page and scan the 'Symbol PTC Terminal (Telxon)' barcode and you'll be all set. I hope this helped. Good luck!

There is no volume control on the Older style PTC960 (black brick on a stick)

Its either on or off. If its not on then its more than likely faulty.

If you need any more assistance please contact us

www.biastechnology.com

[email protected]

for the one that has the 42 prompt.

hit the 6 key
TP__ will show
type in 59 then hit enter
hold the 3 key for 3 beeps
turn the device on

800-933-2839 x240