Question about Washing Machines

1 Answer

No manual for Hoover Logic 1250

Need gide to choice of cycles - have no idea which is hot, cold, delicate, etc. There is no manual available.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,314 Answers

Try here you must have your model number off the serial plate on the washer http://service.hoover.co.uk/manuals/?Section=2

Posted on Mar 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have just moved into an Apartment with a Gorenje wi 62112 Washing machine, I have no manual Can anyone tell me what the numbers on the Dial mean What should I choose for a general wash.


Gorenje has some documentation for their washers here: http://www.gorenje.com/simplicity/en/washing_machines/simple_manual_for_washing . The numbers indicate the water temperature (in Celsius) for a given cycle. The common choices are a cottons load in hot water (60 degrees). This is great for towels and other whites. The mixed load is for permanent press that can be in warm water (40 degrees). Then there is a cold water cycle for delicates (30 degrees). However, you should check the fabric care label before choosing the cycle.

I hope this helps.

Cindy Wells

Apr 20, 2016 | General Washing Machines

1 Answer

I have an Omega CW 675-A washing machine and I have just moved in but the owner did not leave an instruction booklet for the settings. Is this a free service? Can you help me? Paul


Hi

The particular model number is not listed in the list of manuals of omega washing machine.Please call the customer support for assistance.However given bellow are some settings of the washing machine,which is extracted from a website.Hope it helps:-

7 is warm wash delicates (warm cycles then it runs through the number 10 delicate cold cycle too)
10 is cold wash delicates
1 is the longest regular cycle
I normally wash with only the cold tap on, 3 for dirty washes, 4 for regular washes.
Soap goes in the middle slot
3 Buttons from left to right
left - in to spray rinse
middle - in to NOT spin dry
right - in for NOT boost heat (or maybe it has no booster and it is just in for cold wash - not sure)
when standing in front of it, reaching over the back, the left connector is cold and the right connector is for hot water.

Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com

Aug 09, 2011 | Washing Machines

1 Answer

Hoover nextra washer was showing fault code 3. on inspection i found a ten pence piece in the in hard plastic pipe of the pump. removed blockage and set it to cycle. machine was showing fault code 1. i...


Hi from retired Englishman in SW France,
Hoover Nextra fault code 1 actually decodes as 'door interlock/door switch' (???!!)
Fault code 2 states' fill time-out or solenoid valve etc'
If you have checked that the hot and cold water taps are turned on fully and the hoses are not kinked or squashed at the back, it is worth while checking both the hot and cold water inlet filters. Turn the taps off and remove both hoses at the washer end. Inside each inlet port there is normally a little filter which should just slide out. Clean if necessary and replace each one and the hoses. If after turning the taps back on there is no improvement, the problem is symptomatic of a malfunctioning hot or cold water control valve. Sorry but it needs a service call ;-0(
If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck,
John C

Jun 19, 2011 | Hoover Washing Machines

1 Answer

My washer will not fill with water or do any functions when i turn the dial


My Hoover 7700l ...on "fill" cycle, the water dribbles in. Takes hours to fill so we use buckets to reach the required level.

Tried: Swapping cold and hot water inlet hoses, making sure that dial is in "hot". This solved the problem for filling, BUT when "rinse cycle appoars, it's back to the dribble again.

any ideas?

Jan 23, 2011 | Maytag LSE7806A Top Load Stacked...

1 Answer

Zanussi 1250 aqua cycle washing machine can it run on cold water only


If it has 2 inlets at the rear, then you need to connect the cold supply to the hot and cold inlets by means of a Y piece, available from most major retail stores like B&Q, or a plumbers merchants.
If only 1 water inlet, then simply connect to the inlet valve.

Aug 14, 2010 | Zanussi Washing Machines

1 Answer

The washing machine won't start if "cold water" only is selected. It will only work when "warm water" or "hot water" is selected (and even then there is only hot water filling the machine, the cold water...


Check the cold water solenoid. If a meter is not available you can swap the hot and cold wires and see if the symptom changes to hot water when cold is selected. If so the mixing valve needs replaced. If no then further testing of the wire harness and timer circuit are needed.
Eric

Apr 13, 2010 | Kenmore 13202 Top Load Washer

1 Answer

Won't let in cold water. set on delicate, it used


remove cold water supply hose, if all is well and screens are clear , means cold water valve is faulty

Jul 25, 2009 | Equator EZ 3600 CEE Front Load Washer /...

1 Answer

Hoover HW160m - double inlet but only 1 tap at new build.


Hello,

You can use the cold water only with no issues at all. The only thing you will have to do is buy a cap to block off the hot water inlet on the back of the machine otherwise the cold water will flow out through it onto your floor etc.

And yes, your machine has an element built in which will heat the water for you!

Regards,
Adrian.

Jun 18, 2009 | Hoover HW160M Front Load Washer / Dryer

1 Answer

Hoover 1300 spin 5+5 washer dryer


you don't say which cycle it will start on. however, could be cold valve open circuit which also means no rinse or cold inlet hose kinked etc. can you give more info?

Apr 09, 2007 | Hoover H120M Front Load Washer / Dryer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...