Question about Dishwashers

3 Answers

Maytag jetclean eq plus dishwasher: soap problem

I have a Maytag jetclean eq plus dishwasher. Once in a while, the soap get stuck in the dispenser. Result, dishes not clean and soap everywhere.

Thanks!

Posted by on

  • 1 more comment 
  • Anonymous Jan 02, 2009

    same problem- dishes all have residue on them- have to rinse them off by hand

  • Anonymous May 05, 2009

    When  I open the dishwasher ( Maytag Jet Clean Quite Plus II ) after it has run, I find the soap door open but the soap tab is only partially disolved, still in the dispenser. The dishes are not clean, but I know the water has run because I opened the dishwasher mid-cycle and found plenty of hot water spraying everywhere.

  • Anonymous Mar 15, 2014

    My clean and normal wash are blinking. The systems starts at 85 minutes then never goes past 84 and then starts blinking

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

This could be due to 2 problems: not enough water or water is not being pumped hard enough through the system. The 'not enough water' is easy to check - open the door in the middle of a wash cycle. If you have enough water (about 1" or more) then that is probably ok. The 'not pumping hard enough' could be as simple as plugged up filters and holes in the spray arms. Remove the racks and disassemble the lower spray arm and the filter assembly all the way down past the screen. Clean the arm holes, throughly clean the screen, clean everything. Pull the top spray arm and throughly clean the spray holes there. Put it all together and run a cycle. You should see a pronounced increase in the sound of the water spraying around. This should fix your problem - it did for me.

Posted on Jul 15, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have the same dishwasher and have had the same problem. What I've personally observed, however, is that sometimes a long utensil in the silverware basket prevents the soap dispenser door from opening. Simply make sure the long items are not placed in the basket closest to the soap dispenser door.

Posted on Jul 15, 2008

Clean the filters

Posted on Jun 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maytag jetclean dishwasher eq plus


The best dishwasher soap we have found is Finish Quantum and they have good rinse aid too

Jan 24, 2014 | Dishwashers

1 Answer

Maytag jetclean eq plus mdb9150awd Stalls at 68 min


Could be defective timer. The diagram might be on the back of the machine - out of sight, out of mind

Jul 24, 2013 | Dishwashers

1 Answer

How do I replace myself the detergent/rince aid assembly on a Maytag Jetclean dishwasher EQ plus model #MDB9150WB? I only need to replace the door, but I don't see a part for that, just the entire...


Carol,
This is a simple repair. Remove the screws around the outer door edge and separate the door. The dispenser is clipped into position with several screws. Remove the screws and push the dispenser through the door.You can purchase the part from the link below.
Appliance & Refrigerator Repair

Mar 23, 2011 | Dishwashers

1 Answer

Maytag Jetclean Dishwasher EQ Plus - Lights flashing


either the control board or the control panel needs replacement. Most likely the latter. There is a possibility that both parts failed also. Usually water gets inside the touchpad, corroding and shorting the touchpad. Good luck

Mar 03, 2010 | Dishwashers

1 Answer

Maytag dishwasher soap dispenser won't open durning wash


Just put a soap tablet in the cutlery basket. Normally after a couple of washes the dish will start working again

Apr 02, 2009 | Maytag MDB9600A Jetclean II Built-in...

1 Answer

Maytag Jetclean Dishwasher EQ Plus MDB7100AWB


the door seal has gone better change the door surround seal also. check for case damage and obstructions aswell.

Mar 14, 2009 | Maytag MDB7100AWB Dishwasher

1 Answer

Soap residue on all items after dishwasher completes its cycle.


Hi Rioski

The first thing to do is where you put the jetdry turn it down to one. use powdered detergent the best is electosol is the blue box,dont use the heated dry feature and run the hot water at the sink first to get it good and hot that should fix the problem. I also recomend using GLISTEN every 6 months. its a citric acid that is designed to clean the dishwasher. i hope this helped.


brent

Oct 01, 2008 | Dishwashers

1 Answer

Dishwasher


detergent dispenser solenoid

May 10, 2007 | Maytag 24 in. MDB8600AWS Jetclean II...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

1,994 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

Brad Brown

Level 3 Expert

15133 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...