Len comes on and closes as quick

There are some steps which can be followed which may resolve this problem which as follows,
1: Switch on the camera while you hold the shutter button and connect it to the AC adapter or to the USB cable at the same time.
2: Now by default the lens should get properly aligned if not try to twist them slightly by holding down the camera lens with soft hands.
3: Just push and pull the lens slightly as it extends automatically.
4: Now when the lens is in the hard surface power on your camera.
5: Try to hit the camera softly beside the lens which might solve the issue.
You can try to format the memory card completely and then reinsert to your camera which might be the issue at times.

Long and short of it...if the photos are close to "decent", dont worry bout it :) It aint no L Lens but can still throw out a good pic every now n then. Tip it from one end to the other whilst holding it...if you hear something go \'ring-a-chicka-chink-chink-clunk\', then youve got problems, otherwise grin and bear the looseness - mine lasted 6 years of hard yacker before i dropped it in the drink!

it is a lens error and you can solve it by hitting the lens area with the soft tissues of your palm .. this worked for me..

Need to replace a new len. Len is bad.

This is most likely a problem with the lens. Do you have the switch on the side of the lens at 'A'? Are you able to focus manually? It is a common fault that can occur if the lens has receive a knock or the camera has been dropped. Also, grit or sand in the lens mechanism could cause this. It is recommended that you send this camera to a qualified service centre.

Push lens assembly back into camera gently yet firmly with your thumbs until you hear a click.

Threw it out. Bought a different more reliable brand. Thanks for nothing.

There are two ways to view the photos, in the camera...

1) if the camera is OFF and the lens barrier is closed, just press the Play (>) button once to view the photos.
2) If the camera is in SHOOTING mode with the lens barrier open, press the Quick View button twice in rapid succession.

When you are done reviewing the pictures, press the Quick View button once to turn the monitor off, OR, to return to the shooting mode, press the shutter button halfway.

Then use the arrow pads to go forward and backward.

Hope this helps.

Simple! Read warnings carefully! It said "remove lens cap and press SET button"! So remove the lens cap and then press the SET button (or arrow downward in the four directions button)! You don´t need to RESET anything...

Len, I have had many service calls regarding this problem. The problem is the inside door switch. LG missed the tolerences a little. What I have had to do is get a piece of plastic with some double phase tape, about the same size of the switch and mount it so when closing the door it will put more pressure on the switch. The piece should be at least 1/8 inch thick. I believe LG has come out with a kit but the aforementioned works better...Catriver...post back.