Question about Audio & Video Receivers

1 Answer

Rx-1800 i have a Rx-1800 when playing music i hear a crackling through the right speaker. so i swaped the speakers over right to left - left to right and still hear the crackling through the right side.

Posted by on

  • Anonymous Jan 14, 2009

    I have the same issue on AVR-1803. Constant crackle in the front right speaker only

×

1 Answer

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My receiver only plays front speakers. when i put it in surround mode none of the speakers will play and the sub even in stereo mode is barely a whisper of sound. i dont have a remote for it but it goes...


you don't need a remote. to me sounds like you might have a connection problem. try and do a test tone which will send a test signal to all the speakers. starts from left to right etc. if you cant hear all the speakers you need to check all connection wires etc. hope this helps

Apr 08, 2014 | JVC RX-8000V Receiver

1 Answer

No sound on left front speaker


you need to set up the individual volume levels for each speaker.
do a sound test tone which will check for a signal from each speaker.
if you hear the speakers at different volumes you know you need to adjust the ones that are too weak. hope this helps

Mar 27, 2014 | Yamaha RX-V420 Receiver

1 Answer

Keeps blowing speakers on left front channel


What exactly do you mean by "middle volume settings"? Where is the volume control physically, where are the channel levels set and what is the crossover point? After the crackling appears , do you switch speakers to the right channel to see if speakers are actually damaged or if the receiver is producing the distortion?

Jan 22, 2014 | Pioneer VSX520 Receiver

1 Answer

Why do my right speaker inputs cause fuzzy sound?


HI KYLE...

I think I have experienced this problem before with my Sony stereo set. It could be a sign that your receiver's amplifier is giving out. Best that you can do is bring it over to an audio repair shop for a checkup. If my suspicion is right, you're gonna have to replace it with a new one. Don't worry, amplifier chips are not that expensive.

And lastly, when any part or component is replaced, be sure to ask the technician to give it to you. You can keep it for your reference.

BOB (June 23rd '12 3:20am)

Jun 14, 2012 | Sherwood RX-4109 Stereo Receiver Black

1 Answer

I have a Kenwood KR-V9030 and the right channel is crackling and will not provide increased output when the volume is turned up. 1) Swaped speakers from left to right and the problem is in left speakers...


There is a chance that a common control may have developed a high-resistance or 'dead' spot and is causing your symptom. Turn the POWER OFF and operate every control throughout its range a number of times, especially rarely-used ones like Tape Monitors and the Mute control.

If it still doesn't work you might want to prove if its a low-level signal loss or a high level amp failure.

One way would be to run an RCA cable pair from the Tape Out to any other device (even a TV with speakers) you might have that accepts an audio input. If IT can't detect receive the DEAD Channel you're losing it in the preamplifying or source selection stages.

If it CAN be played externally, the receiver is losing it on its way to or at the amplification stage. Further isolation would require hands-on technical expertise.

Apr 16, 2011 | Audio & Video Receivers

1 Answer

Volume keeps getting louder on the right


I solved the problem but i am not going to tell you how because you were trying to charge me money to get advise. that is bull ****!!!!!! give me a life time subscription for free and I will tell you my expert opinion

Aug 26, 2009 | Yamaha RX-V870 Receiver

1 Answer

I have distortion coming out of my front right channel of my AVR


Yes, sounds like your DSP chip has an issue. Not an inexpensive repair if that's the culpret. Around 400-500 to replace the chip. It's an awesome receiver and worth 300-400 in repair, however, a 3800 or 1800 can be had for 600-800 depending where you look. If you need more help, post a comment and I can help you some more.

Aug 10, 2009 | Yamaha RX-V2600 Receiver

2 Answers

Rx-v461


but does it sound normal in all other sources?

Feb 18, 2008 | Yamaha RX-V661 Receiver

1 Answer

JVC RX558 VBK, Crackling noise from speakers


A quick quess of mine is the following:

The OVERLOAD indicator lights up when the receiver is maxing out on the current it is sending to the speakers. My guess is there is possibly something wrong with the receiver itself, especially since the B speakers won't play. Either that, or something is broken in your speakers or you are using a set of speakers that have too low an impedance rating for your receiver.

Apr 23, 2007 | JVC RX-558V

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68157 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...