Question about Barebone Systems

1 Answer

Hp all-in-one C4100 series, will print off internet, but not pictures and will not print off microsoft works, will not fine camera or print cards.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 458 Answers

Did you load all of the drivers from the driver disk?

Posted on Mar 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I no longer have my manual, how do I change the ink cartridges for the HP Officejet 6300 all-in-one?


To replace the print cartridges
1. Make sure the HP All-in-One is on.
Caution If the HP All-in-One is off when you open the print cartridge door
to access the print cartridges, the HP All-in-One will not release the
cartridges for changing. You might damage the HP All-in-One if the print
cartridges are not docked safely on the right side when you try to remove
them.
2. Open the print cartridge door.
The print carriage moves to the far right side of the HP All-in-One.
3. Wait until the print carriage is idle and silent, and then lightly press down on a
print cartridge to release it.
If you are replacing the tri-color print cartridge, remove the print cartridge from the
slot on the left.
If you are replacing the black or photo print cartridge, remove the print cartridge
from the slot on the right.
4. Pull the print cartridge toward you out of its slot.
5. If you are removing the black print cartridge in order to install the photo print
cartridge, store the black print cartridge in the print cartridge protector or an
airtight plastic container.
If you are removing the print cartridge because it is low or out of ink, recycle the
print cartridge. The HP Inkjet Supplies Recycling Program is available in many
countries/regions, and lets you recycle used print cartridges free of charge. For
more information, go to the following website:
www.hp.com/hpinfo/globalcitizenship/environment/recycle/inkjet.html
6. Remove the new print cartridge from its packaging and, being careful to touch
only the black plastic, gently remove the plastic tape by using the pink pull tab.
7. Slide the new print cartridge forward into the empty slot. Then gently push on the
upper part of the print cartridge forward until it clicks into the socket.
If you are installing the tri-color print cartridge, slide it into the left slot.
If you are installing a black or photo print cartridge, slide it into the right slot.
8. Close the print cartridge door
9. If you installed a new print cartridge, the print cartridge alignment process begins.
10. Make sure you have plain paper loaded in the input tray, and then press OK.
11. The HP All-in-One aligns the print cartridges. Recycle or discard the print
cartridge alignment sheet.
12. Press OK.

Jul 17, 2011 | Barebone Systems

1 Answer

I don't know that which paper is best for pictures with hp j410


Hi,

Usually pictures are best printed on Premium Glossy Papers on Best Image Settings.

Mongkey

Feb 14, 2011 | HP Barebone Systems

1 Answer

Camera professional lens 10x option zoom f=4.3mm


Hi there please follow the steps and let me know the result.
1. Ensure batteries are fully charged & clean the battery connector point in side the battery compartment.
2. Look carefully between the lens and the camera body for any sand, dirt or any damaged etc.
3. Try turning the camera with the lens facing down and shake to dislodge anything stuck
4. Try removing batteries and memory card, wait 5 minutes and refit the battery only.
5. Now turn on camera( with out card ) and see ,if working then fix the memory card & again turn on the camera. If working then fine . Otherwise format the memory card and fix back in camera again & try. Make sure before format the memory card take a back up all photos in your computer then format. If no luck then reset or restore the camera setting by pressing Menu key for 2 sec .. in not done the press both Menu & self time key for 2 - 4 sec.
i hope it will gives you success. Thanks & Before you leave, if you have found my information helpful and if you haven't already done so then please press the ACCEPT button, this is how I am paid for helping you today. POSITIVE feedback & bonus is appreciated

Feb 05, 2011 | General Barebone Systems

1 Answer

I HAVE A HP OFFICEJET


when you go to print click on the Preferences button ,in there it should give you the option to fit to page ,or option to print at a %. you may have to hunt around for it depending on what o/s you are using

hope this helps
Terry

Mar 14, 2008 | Barebone Systems

1 Answer

Two weeks ago my computer creashed, lost everything,a technican has reprogramed most stuff,my printer does'nt print from the computer, its all hooked up,the technican gave me a Epson stylus C20 Series...


I have no clue why he would give you an Epson disc. Anyway, you can download your driver from HP's Site.

1. Unplug USB cable to printer, then from Control Panel > Printers delete any printers there.
2. Reboot
3. Install new drivers from the site above.
4. Plug USB cable back in.

Enjoy
Geno

Mar 10, 2008 | Barebone Systems

1 Answer

Unsupported printer cartridge


uninstall printer, reboot and then reinstall using the lexmark printer cd or downloaded drivers.

Mar 10, 2008 | Barebone Systems

1 Answer

HP Printer Conflict


Perform a clean and "No bloated" installation of the hardware.
Uninstall ALL the HP printer software, disconnect the PSC and reboot the computer.
When windows finish to load, connect the PSC again, the new hardware wizard will show up, follow the instructions with the HP Installation disk in the drive.
IMPORTANT: When a silver sand glass show up in the screen, CANCEL the installation of the HP software (this is by clicking "CANCEL" button or by no accepting the license terms). This will install only the PSC Drivers and nothing else.
Try printing again.

Feb 15, 2008 | Barebone Systems

Not finding what you are looking for?
Barebone Systems Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Barebone Systems Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

john smith

Level 2 Expert

366 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a Barebone System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...