Question about Washing Machines
Approximately every other wash stops mid-way and shows up the error code E90. It occasionally will continue the wash after pressing pause/start a few times Can you help solve what this is or how it can be fixed? Thank you.
SOURCE: Error E90
That happened to mine, and apparently it is the connection to the control panal at the front of the machine or the desplay unit (4 blue wires). Take the top off and wiggle them around or re-connect if any are loose. Mine worked for one wash and then started displaying E10........so i'm not amused and I think i may end up getting a hotpoint!
Posted on Mar 26, 2007
Click on Zanussi (below FIXYA) on this website, type in your model No & search. You will get a shortlist; click on your model,below the page u will get Manual/Guides. Click on the blue, you have your manual on line.
Posted on Jan 01, 2008
SOURCE: Electrolux 1087 E90
I found out the hard way that it's because the drain is blocked. Check the filter and even get a torch to look to make sure there is no coin or piece of wire jamming the pump.
Posted on Aug 27, 2008
Tips for a great answer:
Nov 13, 2016 | Simpson Washing Machines
Dec 23, 2015 | Washing Machines
Hey friend, thank you for your post!
From my understanding you are receiving an error code of "E90" on your Frigidaire washer. I am showing that as an invalid error code. It might be a miscommunication with your control panel and I would suggest performing a reset on your washer. In order to reset the washer you would need to disconnect the power from it for roughly ten minutes. If you continue to receive an error code of "E90" I would suggest contacting a professional technician for proper diagnosis and repair. Hope this is helpful. -Matt
Feb 17, 2015 | Frigidaire Washing Machines
Feb 12, 2015 | Electrolux EW1000i Front Load Washer
Jan 10, 2011 | Washing Machines
Feb 28, 2010 | Electrolux EW1200i Front Load Washer /...
1,450 people viewed this question
Usually answered in minutes!