Question about Projection Televisions

1 Answer

Tv repair I need a replacement part and someone to replace it on my norcent lt-3225 tv. Part number 8OTL-3-LS LSE-B9 O6O6F3.. I live in Bedford Texas zip code 76022.

Posted by on

  • Anonymous Dec 23, 2008

    I've had these transformers burn out in two HP L1955 flat screen monitors. After the second one, I unsoldered the transformer from the circuit board, but can't find anyone who sell them so I can put a new one in the monitor.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

What is the part (transformer etc)

Posted on Mar 09, 2008


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need part # for Sony KP-51ws500 D board, and


Hi,
Required D board part number for KP-51WS500 is appended below:
A1300417A... D COMPLETE BOARD
Available in Part Store, click the link for price info.
Thanks.

Jun 04, 2010 | Sony KP-51WS500 51" Rear Projection...

1 Answer

I am looking for a replacement lamp for my Viore DLP TV Model number RPT50V24D. Can you point me in the right direction? Thanks. I live in Southeast Texas near Beaumont.


Hi Friend,
Please find the below mentioned address of Best service Centers near by for you

1) Flip On Electronics
1810,Washington Blvd Beaumont, TX
Phone Number: 409-833-3272

2) BEAUMONT Electronic Service
Lumberton, TX
Phone Number: 409-833-1209


Regards,
Ayyasam

Mar 18, 2010 | Projection Televisions

2 Answers

MITSUBISHI WS-73909 will not turn on 1. I have a Mitsubishi Big screen TV model no WS-73909. Few days a go the city power went out when the TV was off. The TV had a surge protector. Then the TV will not go...


Are you a Quailified Technician ? Because this repair is not for the novice. The best thing I can tell you is contact a Mitsubishi Authorized repair center or tell me what area you live in and I can find one for you. cost is 250-350 to repair.

Apr 10, 2009 | Mitsubishi WD-65000 65" Rear Projection...

1 Answer

I would like to buy a rca 61 P61960


Hi jkclay841 i live new york and have a RCA REAR PROJECTION TV 61" MODEL # P61960 CHASSIS NUMBER PTK195Y06T
IT POWERS ON BUT IT'S OUT OF ALIGNMENT ON ALL COLORS AND MISSING THE CLOTH THAT COVERS THE SPEAKERS HAVE THE REMOTE SCREEN IS IN GREAT CONDITION ALSO HAVE SOME NEW CRT COOLANT RUBER SEALS ,AND THREE NEW LENCES THAT I WAS GOIN TO REPLACE BUT CHANGED MY MIND PLUS NO TIME.
HERE IS MY NUMBER 347- 847 -3348 IM JOSE

Apr 03, 2009 | RCA P61960 61" Rear Projection Television

1 Answer

Rca 52 rear projection tv wont turn on


sounds like the small signal board issue as the replacement board is over 600.00 You can get the replacement board at the following link for a fraction of that cost. Heres the link you can leave them a email with the model number and the symptoms.
http://servicemanuals.vstore.ca/

Nov 28, 2008 | RCA D52W19 52" Rear Projection Television

1 Answer

Hcn4226w samsung


Hi,

The most common problem with all 3 tube rear projectors is a damaged convergence circuit. The Samsung TVs are easier to repair than many others and the numbers that break down is not excessive. For every Samsung with a convergence problem there are a large number that did not breakdown. The fault is caused by bumps or noise in the AC power, not the TV design. This usually produces colored outlines around heads, etc.

Check out the Convergence Gallery. If you see the colored outlines or color shading as in the Gallery, you have a convergence problem.

This requires the replacement of the defective IC or ICs and any damaged or smoked resistors. Usually there is little alignment required after the repair. If you play with all the adjustments before the fix, hours may be spent re-aligning.

Don't monkey with it.

This is a delicate and difficult repair. If not done by someone with some electronic repair experience, the TV will likely end up as junk or cost considerably more for a tech to fix the damage done.

If you live in Calgary, call me. If elsewhere, find a competent tech.

easyab

Aug 04, 2008 | Samsung HCN4226W 42" Rear Projection...

1 Answer

My Toshiba 50HM66


i suggest checking the lamp. find you owners manual and go through the steps to "replace the lamp" if it is popped and you can see little pieces moving around inside than contact toshiba and they will send you a replacement with credit card numbers of course.

Mar 21, 2008 | Toshiba 50HM66 52" Television

4 Answers

Green LIght Blinking


replace the DM or have someone repair the DM. The capacitors are bad and someone who knows how to repair circuit boards can replace them

Oct 11, 2007 | Mitsubishi WS-55813 55" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...