- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check for a jam in the very top of the machine where the paper is fed into, also in the cartridge bay make sure there are no obstructions.
If this fails then the scanning head will need to be serviced.
Try Unplugging it for a half hour also, sometimes this can assist in clearing error messages.
Hope this helps
It seems that the lens on your machine has dust particles. If you will clean the dust from the lens and the glass they will go off. In order to reach the lens (thats a bar) you are first required to remove the glass and then you will be able to reach the lens on the extreme right hand side.
Are you getting a totally blank copy or just very light. If I were you I would cheak to see that the developer Lock is in the right place. It seats right under the developping unit. It should be locked to the Left. It will move the developing unit closer to the Drum unit..Good Luck
Most likely the the teflon coating on the heat roller is worn or damaged, or you you have fluctuating thermistor voltage.
Either way the fuser unit needs to be replaced. This should be done by a technician.