Performance Issues After Replacing Router

go to google.com and type bell: type the model of your router you can read the details of it.

http://www.manualowl.com/m/Dynex/DX-wegrtr/Manual/197670 Page eight will tell you how to reset the router to default settings, that includes password and everything else.

Here is your solution.

Configure the dynex on another computer that is not connected to the linksys router.
Assuming that your linksys is currently setup as 192.168.1.1
Turn off DHCP on the dynex and setup the IP to 192.168.1.2 subnet mask 255.255.255.0 gateway 192.168.1.1
use a cross over cable and plug each ends to the LAN port on port routers.
you should now be able to ping 192.168.1.2 (dynex router) from your other computers on the linksys router network.
any computer that is connected to the dynex should be able to get a dhcp address from the linksys router.

You should be able to do it from whatever computer you first set it up with under its settings.

I'm not familiar with that particular router, but all of them are about the same. You can go in and edit firewall settings to allow a particular IP address to have access. Don't disable the firewall completely, just set it to allow that I.P address to have full access.

Download the user guide and follow the steps on page 13:

http://www.dynexsupport.com/sites/dynex/dl/DX-WEGRTR_07-366_Final%20CD.pdf

Here is the support page:
http://www.dynexsupport.com/product/?pid=DX-WEGRTR

Click on this link or copy and paste the complete link into your browser.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Dynex DX-E402 router, changing NAT settings(UPnP) to access x-box live. go to router settings web page for router, http://192.168.1.1/, enter user name and password to access settings page. user id is usually admin this also for password. under advanced settings click on forwarding. In listed sub-catagories click on UPnp. click enable. this should solve any NAT issues with X-box 360 signing onto x-box live. dynex dx-e402 was very easy to setup.

Unfortunately, the DX-E402 is not a wireless router, so it can not transmit its signal without a physical cable connecting the router to your computer. If you want a wireless router that can also connect to your ISP, check out the Dynex Enhanced Wireless G Router:

http://www.dynexsupport.com/product/?pid=DX-WEGRTR

You can download the software from here:
http://www.dynexsupport.com/product/?pid=DX-WEGRTR