Question about Thermador SC272T Electric Double Oven

1 Answer

Replaced the displace board and oven is now not working

My display was dimming, so I replaced the touch display board. The oven had been working fine. After I purchased the new touch screen, the oven no longer turns on

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I just had a repair company replace the display, control board and wiring harness on SCD272 double oven to correct a dim display (kit part # 492071). Instructions on kit say that all three pieces must be used together for proper operation.

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Range has a very dim display


I have a Jenn-Air double wall oven with a very dim display light. Replaced c3 capacitor 68uf 35w - with a 100uf 50w cost $1.60 closes size available at Radio Shack and works good as new. Requires soldering onto the circuit board. I price a replacement part for $276.00.

Mar 19, 2014 | Jenn-Air 27 in. Electric Single Wall Oven...

2 Answers

Oven digital lighted display is dim


You need to replace the C3 capacitor on the control board

http://fixitnow.com/wp/2009/01/28/cheap-fix-for-a-dim-display-on-an-oven-control-panel/

You can replace only the C3 - it is 68uF / 35V and you can go to Radio Shack and get their part # 272-1028 - 100uF/35V one. It takes all but 10 minutes to re-solder the new one in place

May 31, 2009 | Jenn-Air JJW8530C Expressions Collection...

1 Answer

My clock and temperature display is dim


Hi, this will happen over a period of time and its just heat related. the control panel isn't insulated properly and , there has been a larger than normal transfer of heat to the inside of the control panel where the circuits are housed.

If this is a problem, i recommend replacing the control board. it will fix the dim issue.

May 22, 2009 | Jenn-Air JMW9527C Electric Double Oven

1 Answer

Display not working


I replaced the C3 capacitor on the circuit board as another person on FixYA had recommend and it works fine now. $4.00 versus $180.00 was worht the chance to try it.

Feb 09, 2009 | Jenn-Air JJW7530DDS Electric Single Oven

1 Answer

Dim light on oven display w30400b jennair


The circuit board is for the display/touch panel. It is mounted on the back of the display panel itself and connected to the other circuit boards by two multipin connectors. When you remove the display panel (3 screws on top, 4 on the bottom) you will be able to GENTLY detach those connectors. They are low voltage and may be handled safety even when the oven is powered, but I agree that turning off the oven circuit breaker is good practice.

To remove the circuit board, GENTLY release the two black plastic tabs; the solder pads are underneath. I too used a 100 mf capacitor because no local supplier had a 68 mf hi-temp. Observe polarity; the (-) lead goes towards the center of the board (away from the edge connector.)

BTW, I had exactly the same symptoms (display goes dim, then goes out altogether.)

Jan 16, 2009 | Jenn-Air W30400P Stainless Steel Electric...

2 Answers

Display light faded and now gone


Supposedly the electrolytic capacitors on the display board need to be replaced. See: http://applianceguru.com/forum1/18842.html

Jan 15, 2009 | Thermador SC302T Electric Double Oven

4 Answers

Oven digital lighted display is dim


I replaced the C3 capacitor on the circuit board and works fine. This was mentioned in a prior post and took 5 minutes and was under $5.00 for the part.

Nov 27, 2008 | Jenn-Air JJW8530C Expressions Collection...

4 Answers

Dim display.


The display sits on a circuit board. Pull the board out and replace capacitor C3. It is 68 micro farads. I used a 47 from Radio Shack and it works great. If you can find a 68, that would be ok too, of course!

Oct 12, 2008 | Jenn-Air WW27430P Stainless Steel Electric...

1 Answer

Thermador model sc272t oven 2 doors have dim display


there is a dispay kit you can order from bosch to fix this problem. it will come with a new display board and power control which is located behind control panel as well

Nov 18, 2007 | Thermador SC272T Electric Double Oven

Not finding what you are looking for?
Thermador SC272T Electric Double Oven Logo

Related Topics:

706 people viewed this question

Ask a Question

Usually answered in minutes!

Top Thermador Ovens Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Thermador Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...