Question about Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher
Error code f17 machine wont spin, (it could possibly be f14)
I had this same message last week. It is to do with the water intake (i.e. the water coming in to the back of the machine). If you have checked that the hose isn't trapped or kinked, unscrewed it and checked the filters at each end for blockages (rinse out if necessary), and you still get the F17 message, it may be because your water pressure is too low, in which case you need to contact your landlord (if you rent) or thames water if the problem is external (especially if there are any works going on near your house). Hope this helps!
Posted on Jun 12, 2009
Low water pressure
Posted on Mar 14, 2008
Tips for a great answer:
Mar 30, 2016 | Bosch Dishwashers
May 29, 2014 | Bosch 24 in. SGS43C12 Classixx...
It is possible that the machine does not start off the cycle because there are errors or feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven from the flow into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.
If the water flows then the flow should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash.
Finally after the wash the drain valve will be activated, the water is allowed to come in to rinse and then finally the dry spin with the drain valve/pump activated so as to drain off all the water from the clothes during the spin.
Make sure that a fault in any of the cycle will relate to the specified action, so check the command from the program module and then the executing device be it the valve or motor or pump.
Please check the link below:
Thank you for using fixya.
Aug 11, 2011 | Bosch Dishwashers
Apr 23, 2011 | Dishwashers
Aug 14, 2010 | Miele Premier-Plus Built-in Dishwasher
Mar 11, 2010 | Bosch 24 in. SHU43 Built-in Dishwasher
Dec 27, 2009 | Dishwashers
Dec 23, 2008 | Bosch 24 in. SGS43C12 Classixx...
Jun 16, 2008 | Miele Dishwashers
Sep 04, 2014 | Bosch 24 in. SGS43C12 Classixx...
5,034 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: