Question about Eureka WhirlWind 4381 Upright Vacuum

1 Answer

Install filaters which filter goes where??

Posted by on

  • violin2 Mar 08, 2008

    which filter goes where on my eureka

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 148 Answers

Not sure which filters you have ... i will assume you have a replacement cassette micron filter -- goes in the compartment on the front of the vacuum just lift up the handle on the compartment and swing upwards it will pull out like one large piece the filter is on the back. the cassette door will be hinged at the bottom so just pull firmly from the top and snap back in place after replacing the filter. Replacement HEPA filter cartridge --- attaches to rear of Eureka upright vacuum cleaners. Here is a pictorial or changing the filters : http://www.eureka.com/servlet/FindOwnersGuide

Posted on Mar 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My bissell is spitting out dust


not installed properly could be the fault .

Aug 05, 2016 | Bissell Homecare 47B2 - Bissell ReadyClean...

1 Answer

N2000 clean filter


The red guard goes on top of the foam after it is installed. The purpose of the red guard is to keep the bag from sucking down against the filter when you get a few inches of dirt in the bottom of the bag. If it sucks down against the filter the dirt in the bag will cause an airlfow restriction even though the bag is not full.

Jan 25, 2014 | Riccar Vacuums

1 Answer

How do the filters go back in my Eureka Whirlwind Lite 12 amp vaccum?


There are two filters for the this vacuum. The first goes behind the dump cup and there is a filter pack for that below.
Filter Value Pack. Eureka Part #60951A - Free Shipping

The second filter goes in the back of the machine the part you need is below:
Generic Eureka HEPA Filter Designed to Fit Style HF-5, Eureka Part # 61830 - Free Shipping

Apr 13, 2010 | Eureka Whirlwind 4388 Bagless Upright...

1 Answer

Dirt keeps coming out the back of the vac. I have a D:ayton 1D457D wet/dry vac. I have aring that says to use on dry applications only. Where does that ring go?


the ring goes over the filter insid the vac where the filter is.take the filter out and cleanit real good then put it back on.now the ring goes over the filter and get pushed all the way to the top and pressed on to hold the filter in place

Apr 23, 2009 | Vacuums

1 Answer

Filter trouble


take the dirt cup off the filter goes inside the dirt cup.once you have the dirt cup out twist the top and it will come off,take the old filter out put the new in then twist the cover back on and put it back on the vacuum.please leave feedback

Mar 15, 2009 | Dirt Devil Featherlite Bagless Vacuum...

2 Answers

I have a hoover windtunnel bagless that the filter fell out of on accident when I was trying to dump it and I can't figure out how to put it back in


Hi, You don't say which model windtunnel you have but most are the same. The canister is in two sections with a Hoover emblem to the right of the handle. this is the side the filter goes on. The bracket slides out and holds the round filter, the round filter snaps into the bracket so that the end of the filter with the opening goes down to fit the hole in the bottom of the canister. When putting the canister back in the vacuum be sure the top goes back flat on the canister and the locking lever is open all the way. You have to slide the canister back in level and then it will drop down into position you can't tilt it. now you can lock it. Good Luck!

Jan 29, 2009 | Hoover Ultra U6430-900 WindTunnel Bagged...

1 Answer

Filters


Okay simple. You should have 3 filters. A foam, plastic and a round paperish filter. Foam filter goes around black air filter which goes in the bottom removable tank and then the grey one goes in the upper tank and twists in

Dec 05, 2008 | Bissell 6594 PowerForce Bagless Upright...

1 Answer

Installation of a Dyson filter


Hi Nancy.

Thre are 2 filters on the DC4.
The first is A one piece filter which colud just be circular pad or purple plastic hepa filter this filter fits directly on top of motor.
To fit this remove the wastebin & vortex head from machine now look down on top of machine you will see A circular cover with fins on it remove this & this type filter goes in there.

The second filter will be yellow plastic frame which has circular foam insert inside it the foam is normally blue & can be pulled out so you can wash it.
This filter fits directly on top of vortex unit, To fit this filter push button near handle on the top of wastebin & vortex the lid of vortex will open you wil see A ring of holes the filter goes in here shut the lid & thats it done.

http://dysonmanuals.llc.nu/

Aug 03, 2008 | Dyson DC17 Animal Bagless Upright Cyclonic...

Not finding what you are looking for?
Eureka WhirlWind 4381 Upright Vacuum Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eureka Vacuums Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18298 Answers

Ryan S
Ryan S

Level 2 Expert

328 Answers

Jim Parker
Jim Parker

Level 3 Expert

1040 Answers

Are you an Eureka Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...