Timing marks i need to know how to line up the timing marks on a 94 honda accord 2.2L

there are lines on the cams that need to line up with each other in the center and there is a mark for the crank gear that you line up with the little triangle mark behind it.If you line up the white mark on the crank pulley and have the valve cover off so you can make sure you dont have the engine 180 out and dont move anything once you remove the tensioner you should do fine.

For the 1994 Honda Accord 2.2L SOHC In-Line 4-Cylinder:
Firing Order:
1 - 3 - 4 - 2
Cylinders:
.........(back)..........
|...4....3....2....1...|
.........(front)
Distributor:
......4
3..........2
......1.......\\\\\\
........\\\\\\\\\

Let me know if this helped. Thanks for using FixYa.com!

looking at cam sproket front, it will be to the left hand side in line with the valve cover surface and crank shaft pointer on timing cover TDC should be white pointer no worries mate

Hard to explain here... but I believe that car also has the balance shaft which needs to be timed as well. The camshaft has 2 lines which line up to the top of the head, and a "up" or "top" mark at the top.
Crank is set to 0 degrees.

If your replacing lines that thread into calibers or wheel cylinders,
The auto parts store will know which lines to give you,after you give them your cars make and model.

Well basicaly there is no adjustment it has timing marks and the belt goes on with the marks on the points.cam pulley has a stamped mark up with line marks that go evenly one on each side has to be even with top of the head.crank pulley the woodruff key goes straight up facing the cam pulley.The balance pulley has a v mark on the pulley and a mark on the block and those go together, dont worry about the water pump there is not timing mark on that.Good Luck

HI train fixer
You would find the following utube site helpful----- dave's farm I think he has a clip on this.

there is timing marks on the camshaft where you line it up it can be difficult

i have a honda accord 2.2 and the timeing belt has 2 belts i have the main belt lined up but the small bet dosent have any markings to line it up with how would i line it up with out one

Rotation is clockwise. The writing faces the tire.