Question about Xtant A2002 Car Audio Amplifier

1 Answer

Red light When i turn my car on the amp only has a red light showing on it does this signify it is working or that it is problematic?

Posted by on

  • 3 more comments 
  • howie21 Mar 08, 2008

    it is an xtant a2002

    i actually have 2 of them and both do the same thing

  • howie21 Mar 08, 2008

    it doesnt say anything to my knowledge

    this is the picture of it with the light that shows red circled



    http://tinypic.com" target="_blank">http://i25.tinypic.com/2u43epv.jpg" border="0" alt="Image and video hosting by TinyPic">

  • howie21 Mar 08, 2008

    i do not

    i purchased the car about 6 months ago and it was all insalled when i got it

  • howie21 Mar 08, 2008

    ok just found out that it just means its on haha

    thanks for the help though

  • Anonymous May 08, 2008

    red light on no sound

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Some amps have a protection light to keep you from burning it out you might have a cross speaker wire what kind of amp is it

Posted on Mar 08, 2008

  • 2 more comments 
  • tony sanders Mar 08, 2008

    what does it say by the led (light) power or protection

  • tony sanders Mar 08, 2008

    with car off remove speaker wires off both amps then turn head unit on what does it do

  • tony sanders Mar 08, 2008

    do you have the manual ive never seen one of those amps but if yougive me more detail i know i can help you

  • tony sanders Mar 08, 2008

    was everything working when you first got it

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenwood kac 628 red light comes on and no audio output


The red light you describe on your amp, is the protection mode warning light. An amp goes into protect for many reasons. Here's a checklist.

1st check the fuse (s) on your amp and make sure they are not blown.

2nd check the inline fuse next to your car battery (if you have an inline fuse)

3rd, disconnect the speaker wires with amp on, does the light go off?

4th check your ground, this may be ok if you have tried another amp with the same wires.

5th.if none of these turns the protect mode off, it may be an internal fault.

you may have blown transistors and it is a tricky job to repair and costly.

Jan 28, 2013 | Kenwood KAC-628 Car Audio Amplifier

1 Answer

Red light


You have not got your subs wired up poperly, End it fried the ouputs on the amp, Live end learn (Dude)

Nov 10, 2012 | Nitro BMW-482 Car Audio Amplifier

1 Answer

What does it means when the red light on the amp turns on ?


it shows that there is overload one out put or any short of wires happening or speaker mismatching has been put purely dc .if ant of these happens the red lights indicates danger/warning check ground wire also should be very strongly connected.

Aug 08, 2011 | Mmats D210005 Car Amp

1 Answer

I bought a MTX Terminator amp and the light is red when I turn it on, but it works. Red usually means protect mode but it works fine. Should the light be red or green?


all depends on that amp... if there was an issue it wouldnt work, and the light would be by a protect symbol... if its just red next to the power symbol i say no issue.

Feb 18, 2010 | Car Amplifiers

1 Answer

Amp won't turn on, red light on amp is flashing


DID THIS JUST HAPPEN ALL AT ONCE ? OR DID IT GRADUALLY HAPPEN? CHECK GROUND FROM AMP , INSTALL ONE FARAD CAP . STOCK RADIO ISNT REALLY HELPING , MOST AMPS OF TODAY TAKE A HIGHER SIGNAL FROM HEAD UNIT . ADD ONE FARAD CAP AND SEE

Jan 17, 2010 | Car Amplifiers

1 Answer

Amp runs but then will just turn off and red light comes on


you may have fried the amp pre outs in the head deck, try the amps on another stereo

Jun 01, 2009 | Lightning Audio Bolt B2.150.2 Car Audio...

2 Answers

Red Light


that means you probably have a shorted speaker wire, a bad speaker or the amp itself is bad, try disconnecting the speakers one at a time and see if it turns on or not. if the red light stays on with no speakers hooked up it means the amp is bad

May 30, 2009 | Kenwood KAC-7252 Car Audio Amplifier

1 Answer

Red light comes on but amp still tries to kick.


Try removing the caps out of the system. It sounds like they have gone out. What is happening is the caps start storing up the power like they are supposed to do but then they are being discharged as soon as they are full. Bypass the caps and that should correct your problem.

Mar 14, 2009 | AudioBahn A2300HCT Car Audio Amplifier

1 Answer

Pt- red light on


mine done that the other day and i took the fuse out of the side of the amp for about a minute put it back in and came on dont know why it worked but it did hope that helps you l

Aug 25, 2007 | Performance Teknique ICBM-9560 Car Audio...

Not finding what you are looking for?
Xtant A2002 Car Audio Amplifier Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Xtant Car Amplifiers Experts

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Pablo Gonzalez

Level 3 Expert

733 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Xtant Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...