HARD RESET Dell Axim x50 / x50v / x51 / x51v

SC-1031W is a tablet made by Smartab. To hard reset the tablet, you can follow these steps:

1. Turn off the tablet by pressing and holding the power button for a few seconds.
2. Press and hold the volume up button, and then press and hold the power button.
3. Keep both buttons pressed until the Smartab logo appears on the screen, and then release the power button while continuing to hold the volume up button.
4. When the Android logo appears, release the volume up button.
5. Use the volume down button to highlight "wipe data/factory reset" and press the power button to select it.
6. Use the volume down button to highlight "Yes -- delete all user data" and press the power button to select it.
7. Wait for the reset process to complete, and then use the power button to select "reboot system now" to restart the tablet.

Please note that performing a hard reset will erase all data on the tablet, so make sure to backup any important data before proceeding.

Remove the Screen protector from the device screen and then calibrate the screen with the stylus.

If the issue still persists, perform the Soft Reset on the device.

1. Use an unfolded paper clip, or the reset tool at the tip of your stylus.
2. Gently press and release the RESET button inside the hole on the back panel of your device .
3. After a soft reset, a logo screen appears, followed shortly by a Preferences screen asking you to set time and date.
4. All data on your device should be retained.

If the issue still persists, perform the Hard Reset on the device.

1. Press and hold the Power (on/off) button on the front panel of your device.
2. While holding Power, use an unfolded paper clip, or the reset tool at the tip of your stylus. Gently press and release the RESET button inside the hole on the back panel of your device.
3. If you see a progress bar, keep holding the Power button.
4. Next, the Palm Powered screen will appear. Release the Power button when you see it.
5. You'll see a screen that asks: Erase all data? YES = "up" button NO = any other button. Press UP on your 5-way navigator to complete the hard reset.

Your device will then take you through a series of screens to calibrate the digitizer and verify the time and date.
Note: A hard reset does not delete the current date and time. It does restore other settings to the factory default.

To get rid of the Fatal Alert, perform the Hard Reset on the device.

Note:
A hard reset will erase everything on your device. All your data will be removed, and formats, preferences and other settings are restored to their factory default settings.

Follow the steps below to perform a hard reset on your device.

1. Open your handheld.
2. Press and hold the power button on the top panel of the handheld.
3. While holding the power button, use the tip of your stylus or an unfolded paper clip (or similar object without a sharp tip) to gently press and release the reset button. (The reset button is the tiny hole labeled Reset on the back of the handheld.)
4. Wait for the Palm Powered logo to appear; then release the power button.
5. When prompted that you are about to erase all the data stored on your handheld, press Up to complete the hard reset.
6. When prompted, complete the steps to align the screen.

You can do a hard reset by doing the following...

01) Press and hold down the "Calendar" and "iPAQ Wireless" buttons.
02) While holding down these buttons, use the stylus to lightly press the "Reset" button/hole on the back of the iPAQ until the screen goes blank.
03) Release the "Calendar" and "iPAQ Wireless" buttons.
04) Press the "Reset" button/hole again (so that it resets/powers on.)