Replacement screw for flash foot

I assume you're asking about the 283, not the DF-283 which is compatible with digital cameras.

As for the 283, yes, if you put an adapter such as the Wein Safe-Sync between the camera and the flash. Under no circumstances should the flash be mounted directly on the camera.

No the 283 is not compatible with your camera. The 283 is manual only and not TTl. The canon flash is also not compatible with your Olympus. You need an olympus compatible flash.

Use Red wire to Center.Use Black wire to Ground.Other two, just insulated [email protected]

I think there are some listed on Ebay-check it out.

You can get this at below 8$

http://cgi.ebay.com/Vivitar-283-285-285HV-Flash-Metal-Replacement-Foot-NEW_W0QQitemZ160359960375QQcmdZViewItemQQptZCamera_Flash_Accessories?hash=item255632cf37

http://www.hiviz.com/activities/guidebook/sensor.pdf....perhaps this is a help.. not sure..

yes.

atdlee@netzero,com

ebay or superglue

Call Vivitar or B &H.

Please check the trigger voltage.
What, how do I do that, you said!!!!!!!!!?

Here they are:

1. Four fully charged or new batteries into 283.
2. You needs a DVM (Digital Volt Multimeter).
3. Set DVM: DC scale, higher than 10 scale.
4. Black Lead to black DVM and Red Lead to red DVM.
5. Turn ON the Vivitar 283 and wait until light turns Green.
6. Place Black Lead to Outside Silver Contact of the flash.
7. Place Red Lead to Center Silver Contact of the flash.
8. What is the voltage reading? Read the max. V.
9. Anything under 8VDC will be fine.
10. Some versions will be high.

Hope they are helpful to all photographers.

Truly,
Alexander
[email protected]