Question about Audio Players & Recorders

1 Answer

Help with sony reviever still in protect mode

I am still waiting for an answer to my last request for help with finding my fuse in my reciever, i paid for preminum service and wondered if that fee is for one problem use only?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 492 Answers

Fuses in receivers are usuall located within the unit near where the power cord is attached to the board. You will need to open the product with a screw driver to find this. Please be cafeful to not get hurt and unplug the product completly.

Posted on Mar 07, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can not get surround sound to work


Your Protection System probaly come on for some reason,Sony Is Known for that problem, Check on your screen if a red lit warning Staying (protect) Is on.If there is, Try hiting the reciever on the sides or the top of the cover fairly hard when it is turned on, Some times this will work to turn the protect light back off, Sony is bad for there amps end recievers going into the protect mode,

Sep 19, 2012 | Sony STR-DG600 Receiver

1 Answer

No sound coming from fisher reviever!!!!


I HAVE THE SAME PROBLEM PLEASE E-MAIL ME IF YOU FOUND WHAT WAS WRONG scott_jackson94@yahoo.com

Dec 09, 2009 | Fisher Audio Players & Recorders

1 Answer

I HAVE A SONY RECIEVER SRT-DE597 6.1 CHANNEL AND I ITS ON PROTECTED MODE CAN YOU HELP ME UN PROTECTED


Amp output is damaged and needs repaired. Protect mode cannot be deactivated. When amp is repaired and operating normally protect mode will not be displayed.

Aug 29, 2009 | Sony STR-DE597 Receiver

1 Answer

Reciever on protect mode


Hold in power button until unit "clicks." Takes about 20 seconds.

Jun 18, 2009 | Sony STR-DE325 Receiver

1 Answer

I have an old 5 in one reciever sony; i dont see any fuses and my problem is that after turning on it goes to the protect mode flashing prptect. i disconted the entire reciever so i know there are no...


No reset will help this. The problem is an internal short most likely in in one of the amp circuits. This is a relatively simple repair for a service shop. Expect a parts cost in the $40 range. Add in the local labor rate for the total repair cost.

Dan

Feb 01, 2009 | Sony STR-DE475 Receiver

1 Answer

HI, I have a sony v555es amp and it gives me the following error message "protector OPT.....please power off"


You might be trying to push it too hard, or you might have a short somewhere. Disconnect everything from the reciever except its power cord and turn it on. If it still goes into protect mode, then try to find a reset switch (not sure if this is on the Sony, some recievers have them). If it's NOT in protect mode, then you had a speaker wire shorting out on the back. Make sure that you don't have any stray wires when you connect the cables on the back of your receiver. It only takes one strand of copper to short out the amp section. If that doesn't work then pull the top cover off and chech the fuses out. One of them might be blown.

Tom

Jan 01, 2009 | Sony STR-V555ES Receiver

1 Answer

Sony home theatre system


Hi,

Good enws is yout unit is not fried. Bad news is you need to get the protection fuse replaced...

Mar 04, 2008 | Audio Players & Recorders

1 Answer

Stuck in protect mode


Speakers shorted out, blew a fuse. Replace the unit or (cross your fingers and) open up the box and find the blown fuse.

Nov 23, 2007 | Sony STR-DE425 Receiver

3 Answers

Protect Mode


Make sure that you are not asking too much from your system by having a "heavy" bass contour, or processing externally that amounts to the same thing...accordianman

Sep 27, 2007 | Sony STR-DE597 Receiver

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

4852 Answers

The Knight
The Knight

Level 3 Expert

72620 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...