Question about Audio & Video Receivers

1 Answer

No sound I lost my hard drive and had it replaced, now I have no sound

Posted by on

  • abburi Mar 07, 2008

    I am unable to hear sound.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,226 Answers

Hello!
im affraid to answer your question because in most cases you will rate me " thanks for trying" it hurt me but it's ok because i want to help you.

If you have CD utilities enclosed in your Computer then you should install that all. from the chipset, vga, audio until all necessary driver installed.

if you have no cd utilities then tell me the model of your computer and sound card. promise i will wearch the driver for you.

melnavz

Posted on Mar 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

The hard drive was pulled out of the unit while it was running. when the hard drive was reconnected the unit would not recognize it. its and older 2480 without the cd drive. your help would insure that...


I would first try installing this into a desktop computer as a slave drive. Once hooked up you should be able to see if there is anything salvageable, files etc. yourself before you send it in for to an expensive data recovery service.
Take Care
-WN

May 13, 2008 | Audio & Video Receivers

1 Answer

My TV brings up message "No Hard Disk Found" and doesn't show pictures


sounds like the hard drive went in the Digital TV box, call your local tv cable company for a replacement.

May 08, 2015 | Audio & Video Receivers

2 Answers

Marantz SR-14 EX 5.1 Channels Receiver fuses.


Changing the type of fuses in your receiver will not change your sound quality at all.

Jun 07, 2012 | Audio & Video Receivers

1 Answer

My turntable seems to be out of sequence. The motor runs ok, belt seems ok. The platter only begins to rotate if I push it by hand for couple of seconds, then it just wants to return to stop position. If I...


It sounds like your belt is the problem, as that's the most normal reason. If the turntable is reasonably old the belt may have lost elasticity and not driving the platter properly.Check the wear on the belt and replace if it is suitably worn.

Mar 03, 2011 | Audio & Video Receivers

1 Answer

I got to replace 2 fuses from a sound board of a reciever Sony STR-DE935 but I lost the old one and now I don't Know how many Amp and volts should I buy to replace it .where I can get it?


If its the sound board both fuses are the same. but if they blew you may have a bigger problem like output transistors shorted. But try replacing fuses first if they blow again thats your problem. Good luck

Jun 02, 2010 | Sony STR-DE935

3 Answers

I just bought a nexxtech usb powered soundbar 2606301--I have got no sound coming from it ?


One or more of the hints below will probably sort out most USB problems with most USB portable / external hard drives and OTHER devices (though not always)

A few things to check but assumes USB and Windows for other interfaces / operating systems (mac/ Linux) similar steps may be adapted to suit.

1. Ensure it is connected directly to the computer to a USB 2.0 port not a USB 1.0 port as this can have effects on performance and reliability

2. Use only the cables that came with it NOT one that fits that may have been lying around or is longer. Not all USB cables are equal even though they should be)

3. Do not connect through an external USB HUB unless that hub is USB 2.0 AND has its own power supply.

4. Use ONLY the power supply that came with it if it has an external power supply Don’t use any other unless you know it has both the same voltage and current rating e.g. 12V 500mA anything rated below that would not work properly.

5. Always use the same port for connecting your devices. Some devices do not like being switched about. If switched they may want to install software / drivers again. This can be especially true if you move a HUB to another port

6. For FLASH DRIVES you should ensure that the device is set for "quick removal" using the drive control panel properties or use the USB "Safely Remove Hardware" option. If you dont do this there is a very strong chance that any files you transfer may not be there when you plug into another computer.
7. It is possible to remove drives from the enclosures in most cases and connect directly inside a PC to fully check it.
You should also do this to cheack the drives connections are not bad inside the enclosure.
8. If none of the above steps help look at updating the drivers from the manufacturers web site in the support section.

9. If you checked and fixed anything there and still have issues then check your hardware from CONTROL PANEL / SYSTEM / HARDWARE.
Any exclamation marks by hardware need fixing before you investigate any further
SPECIAL NOTES
USB flash drives can fail for no apparent reason.
Sandisk Cruzers are especially bad for this.

USB hard drives should be treated with extreme care.
This is a real hard drive ! and knocks and bumps can quite literally kill them.

Note that if you hear a drive clicking or pinging this could be the worst thing you would hear.
Known as "The Click Of Death"

Nov 01, 2009 | Audio & Video Receivers

1 Answer

Sound drivers in/op


The logitech speakers are plug and play and should need no drivers. Here is the web page: I suspect you need the drivers for your sound card or for integrated audio.

Mar 20, 2008 | Audio & Video Receivers

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68157 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...