My sony davis 10 ' push power prtector'

if your pushing the power protector to on back its a resettable fuse an you have another insue inside shorting it out

Message 2 of 31 (233,090 Views)
Re: what is push power protector message on sony bravia theatre all about and how to get the unit to [ Edited ] Options ‎11-26-2012 07:15 PM - last edited on ‎07-17-2013 10:20 AM by AmandaM

Hello,
Welcome to the Sony Community.

The "PROTECT" and "PUSH POWER" messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. Press the POWER button on the unit to turn off the system, and check the following items after "STANDBY" disappears.

1) Are the + and - speaker cords short-circuited?
2) Are you using only the specified speakers?.
3) Is anything blocking the ventilation holes of the system?

You may also refer to the following link for additional troubleshooting steps.
https://us.en.kb.sony.com/app/answers/detail/a_id/39107/c/65%2C66/kw/39107

Thank you for your post.

The amp is shorted and needs to be repaired

The "PROTECT" and "PUSH POWER" messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. Press the POWER button on the unit to turn off the system, and check the following items after "STANDBY" disappears.

1) Are the + and - speaker cords short-circuited?
2) Are you using only the specified speakers?.
3) Is anything blocking the ventilation holes of the system?

You may also refer to the following link for additional troubleshooting steps.

PROTECT and PUSH POWER flash alternately on the amplifier screen

http://www.avsforum.com/t/944637/sony-dav-hdx466-push-power-protector-flashing-on-display

ola tengo un problema esk yo tengo el sony dav-dz110 cinema esk cuando enciendo me sale push power protector no se por k sale esto si alguien me ayuda se lo agraseria

Always be the audio amplifier IC damaged

could be fuse inside open it up cheak all cheall all conections start with just 1 unit in it

how many times does it blink pause then blink again?