Changing CODE for Younivevrse Electronic Safe

Liberty Safes - Electronic Lock Use - VIDEO: Changing the ...

www.libertysafe.com/video-changing-the-code-on-your-d-drive-z02-lm-..
Liberty Safe ... How to change your electronic lock code ?»¿for D-Drive Z02 ... locks are slightly different, the programming to change the lock code is the same.

How to reset code on an electronic safe - YouTube

? 1:04
https://www.youtube.com/watch?v=_tqTp57YfCw
May 11, 2013 - Uploaded by donutdaveyboy
How to reset code on an electronic safe ... How To: Open A Locked Sentry Safe If You Forgot Combination ...

That is a picture of the Youniverse Electronic Lock N Safe.

Power up the safe (3 x AA battery);
Remove the batteries, then press any key on the keypad;
Replace the batteries & the safe makes a creaking sound;
Factory default open code of 0000 has now been set;
Enter 0000 on the keypad then turn knob counter-clockwise & pull door open.

http://www.stack-on.com/pages/instruction-sheets

look for :Security Safes Electronic Lock Instruction Manual

what make of safe have you got?

If you can get the door open (which I've seen several procedures for), you can reset the panel with the red reset button on the inside of the door on the hinge side. It will beep and the orange LED will light up solid. Now you can type your 4 digit code, press B, confirm code, press B again et voila!

here you go!! i just found it -- scroll down to the picture of the safehttp://summit.38pages.com/customer-service/instruction-sheets/

Help, just boughta Detroit digital safe, code number to open my instructions are locked inside.

Try this
Open the safe.
press the red button on inside of door
entry the new code you want followed by B
Should be good

The operating instructions on the ES20 as per the crappy manual:

Open safe using emergency key provided

Insert batteries in the box inside the door

Opening the safe
a. pre-set factory code 159
b. input 159 (the yellow light will flash and the buzzer will beep), then press B or A button, the green light will be on, rotate the knob clockwise, pull outwards, the door is opened

Closing the safe: close the door, input the code (the green light will flash for 5 secs). Turn the knob anti clockwise, the control system will activate and the safe will be locked

Changing the code: open the safe, press the red button located inside the door, the yellow light will go on indicating the code can be changed. Input the new code (1-8 digits), then press A or B button, it shall be confirmed by two beeps indicating the new code has been accepted and stored. If the yellow light and buzzer beeps 3 times the code is invalid - try again

Emergency Key - store in secure place NOT inside the safe. Remove the override cover in the centre of the face of Safe (its a silver plastic panel with Sandleford Electronic Safe ES20 on it), insert override key (a cyclinder key) - hidden underneath the override cover panel - and turn anti clockwise, rotate the knob clockwise to open door

Changing the Battery - If the red and green light are on this indicates that the batteries are low and require changing. To ensure the batteries have been installed correctly test before closing the door

References:
1. Operating instructions EA Electronic Safe
2. http://www.secustar.com/products-en/estype-safe.htm