PROBLEM THE RED INDICATOR ON MY LCD IS ON I CANT SWICH ON THE TV.HOW CAN I FIX WNEN I START TO SWICH THE TV ON AUTOMATICLY IS SWICHT OF

what TV and this is a default, consult manuel

Main board fault. Contact any service technician.

Your Mother Board on TV Burnt Out,same thing just recently happen to my LCD TV,,,,

Most likely the issue is one of the buttons on the TV is stuck. You should be able to verify this with the TV unplugged and then see if all the buttons seem like they have some play to them. When the buttons are pressed you should hear a little click noise. If you find one that doesn't well then there is your stuck button. You would then have to remove the swich from inside the TV by removing the back to disable that function. I hope that helps : )

[1019 _0165]

Hello
You just try with one amoung the above four digit code to open your TVs lock. Swich off the set, and swich it again On during each code test. Ok

Proceedings

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand.

Wish you sucess.

There is a manual switch on the bottom of the TV. Just flick it on and it should start to work. The switch is well hidden. It had me for a while. I was ready to go back to the store.

cant get sky + to control this tv set

my nokia 6233 mobile cant swich on my friend tell me a mobiles flash software and mobile swich on automaticly. please help me

have you had this probelm fixed mine just starteed to do it and its only 8 months old and I cant afford to have it fixed please help if you can thanks