My ps2 laser wont move or spin the disk it has bin sitting for awhile. and never dropped or abused. what should i do/?

You need to put a small weight ontop of the disc drive and then it should work

It sounds like to laser inside the ps2 is broken. If the console was dropped it could have damaged the eye of the laser and it wont read or recognize games inserted in the machine.

Your laser is dead. You've got to replace it.

That's it.

Your lazer lense has bit the dust. Depending on your model type the first gen systems lazers are very easy to replace. The later versions sony made it harder to replace. You can find out what model you have by looking at the back of your PS2 then you can either call sony or go to there website and find out what generation PS2 you have. Then go from there. Hope this helps

are you a cute blond? i give you alot of credit, but your going about it wrong.
1.you need to know if there is red/blue coming out of the laser.
2.is the laser focusing (moving up and down)
3.the spindle height has to be at the correct height for the laser to read the disk (thus spinning it) and the spindle also had had problems with this unit. (you can clean it up )
4. once it spins the disk it has to read the TOC (table of contents)which means it has to move to the inner most part of the cd
5 send me you name address and if your busy friday! lol

if the laser is moved to the middle of the area and when you first turn it on it doesn't go back to starting possession's then some thing is wrong with the motor drive more than not it's likely you have a crack in the board.

did you unsolder the antistatic jumper from the new laser?

ok...well all of you people are just **** him! the actual problem is that you probably dropped the ps2 and the case lid got a bit lose...... what you have to do (if you dont want to buy a whole ps2 case again) is tap the ps2 on the top of the lid when it goes into the cd browser screen and it will work perfectly fine just make sure you dont tap i too hard or else we will have another problem...lol!

Did you remove the anti static solder blob (point) on your new laser with a soldering iron and solder wick prior to installing it? The symptons your explaining indicate that point is still intact, If so you will need to carefully remove it first then reinstall the laser and try again.

First of all the new laser lens will not allow your Slim to read NTSC UC games if you have a PAL european Console.

There is no reason the New laser should have not read the disc unless it Came to you damaged. It sounds like you know how to replace a laser.