Bosch shu9915uc dispenser assembly will not close.

could be drain hose not connected

ok sir! maybe you have defective motor thats why your unit is in abnormal power.

Hello Andrew,

I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about £50) and it probably doesn't need to be replaced. Some of the smaller components for the dispenser are available separately, so it would be better to work out what's wrong with it, before replacing any parts - or the entire unit.

The dispenser may be receiving an erroneous signal from the controller to open when the dishwasher is in delay start mode. To check this, switch the power off, insert a tablet in the dispenser, and slide the door closed. Make sure it clicks shut fully (push on the arrow on the door)and then wait for a few minutes to see whether it opens.

If the tablet will stay in the dispenser with the power off, there is nothing wrong with the dispenser. If it opens with the power off, you may just need a new dispenser door or a spring. Please try this simple test, then get back to me for further assistance.

Regards,
BElectric

Hi


White film deposits are observed if water is hard or when you are using more detergent than needed, try filling detergent cup half way. Try using white vinegar after the wash cycle is complete, run a complete cycle. Also turn down the heat on the hot water fed to the dishwasher. Try using water softener for better results.
You can also add vinegar in the final rinse cycle. Make sure that your soap dispenser drawer is opening and closing fine.

Hope this helps... Please post back if more information is required.
Daniel

Just follow the inlet hose in the machine. Check the other end. You will reach the valve. Generally it is located close the hose only.

either water valve is stuck open or fill switch assembly is not working

Hi, the problem is the water valve itself. Based on your description and the fact that this is a common issue with Bosch dishwasher's a new valve will resolve the problem. You'll need a new valve assembly part # 425458 and it's available at most part's places or online. It is about $25 - $30. Let me know if I can assist you further. Thanks for using "fixya" for your inquiry. Please take a second and rate the info provided for you here. Good luck. Macmarkus :)

Your drain hose height could be to high up. Try lowering the level of the hose. Shorter distance the less amount of water is remaining in the hose after pump stops. If the problem continues, check the valve that open and closes the water supply and drain and make sure it is closing. Probably just drain eighth.

http://userguides.50webs.com/

They have the largest manual database, I have
come across and the carry every Bosch product manual.

hi there your dishwasher has gone into flood protection mode ie. water has leaked into the base and activated the float switch.

to try and locate the leak tip your d/w back to drain the water from the base then remove both side panels and start a program to see if you can see where the water is leaking from, being careful not to touch anything while the d/w is running as live parts are exposed

hope this is of some help