E3 i think i know the problem

I was just going through few sites and came across your site
I really liked the way you have presented your site. I was reading some of your content and really found them interesting and informative.
Please see this also - Keep Up To Date Computer Drivers With Driver Tonic Articles Reader

Hi if the electrician installed your dishwasher Or (fixed it) he didn't !!, I'd ring the electrician and get him back....AND SHOULDN'T COST ANY EXTRA.......

CLOGGED WATER PUMP HINDERING DRAIN AND SPIN CYCLE

Abs sensor could b the culprit.

You have to make sure that the thermal Fan is working correctly. if it doesn't work please contact nearest toshiba service center

The E3 code is indicating a problem with the motor.

You should call for service as soon as possible if the machine in under warranty.

Good luck from Detroit, MI.

Hi,

e3 means that the control board is detecting current going to the motor, but the motor won't turn properly. If the error code comes up all the time as soon as you press the power on button, then it means your control board is bad and reading incorrectly. If it only happens during a cycle, then you need a new motor unfortunately.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

E3

Cause: The water heater element does not work properly or the filter mesh is blocked.
Remedy: Clean the filter mesh and if the problem continues please contact service

If the cycle does not stop draining that is usually because of a faulty membrane switch that controls the water level in your appliance.
The faulty sensor cause the machine to think that there is still water inside, even when water has drained completely.