Question about Creative Labs Zen Digital Media Player

2 Answers

Cant get radio signal - Creative Labs Zen Digital Media Player

Posted by on

2 Answers

How do I change the radio stations?

Posted on Mar 22, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Have you made sure you in an area with Radio signal?

Posted on Mar 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a nexxtech am/fm/radio reciever model 1219178.I cant get any radio stations am or fm.was working fine in living room. now by window in basement.what can I do to get stations again?


Radios receive their signals from the airwaves. Since most homes are frame construction and have quite a few windows, radio signals tend to do well in first floor and higher settings. In high-rises, condos, and basements, where masonry construction is prevalent, signals are weaker or non-existent. If the radio has the ability to attach an antenna, you could use a dipole and fasten it up near or to the window to attempt to get better signal. This will or should help with the FM, but AM in that location is almost impossible. If the dipole doesn't work, there are outdoor antennas and there are some amplifier antennas that are available, but this increases cost.

Nov 20, 2015 | NexxTech Audio Players & Recorders

1 Answer

Cant tune my radio in on my X5


This is probably due to a poor antenna connection. Assuming this is the factory radio, you will want to check the connector in the rear cargo area (drivers side pillar).

Mar 28, 2014 | 2006 BMW X5

1 Answer

No out power or no signal back but meter wiggle


Have you tried another mic, on cobra and unidens you have to have a good mic for them to work.

May 02, 2010 | Cobra 29 LTD CB Radio

1 Answer

I cant get signal why?


Could be a number of reasons. These radios operate using FM, which transmit and receive most effectivel on a line of sight. If you have something physically blocking you like buildings, hills, any obstruction..., you could then have problems with reception.

Sep 05, 2009 | Motorola Talkabout T5500 (7 Channels)...

1 Answer

I just subscribed to xm, but i cant get a signal to my car. i can hear the xm preview stations,but cant get a signal. any suggestions?


Be sure that the radio ID is correct with the information given to XM. If you have the right radio ID ask them to resend the signal. Also be sure to go into menu to be sure that you have good signal strenght.

Jun 12, 2009 | XM Radio (XMP6000)

1 Answer

Radio signal strength not very good


It is due to the vehicle antana. you need to purchase a antana booster. hook it to a 12v power plug antana from car to one side of booster and radio to other side. this will increase signal from car antana to radio and should fix problem. most boosters can be found at any car audio or truck stop and run from$10.00 - $25.00 good luck

May 21, 2009 | Goodmans CD car radio GCE358MPT CD Player

1 Answer

Tuning of dab radio


Planet rock is quite a small networking station and its outgoing signal is not all that good. Some personal radios simply just havent been made good enough to find a station with such low radio waves. You may just need to buy another or findout over the net the signal of planet rock or weather they've closed down or not.

Jan 01, 2009 | Audio Players & Recorders

1 Answer

Help me!!!


SWR OK? Is it throwing a dead-key carrier? No carrier? Midlands many times will show what looks like a processed modulation signal but is not going out your finals on the radio, and out the antenna. Suggest an external in-line meter to see if there really is a transmitted signal. If there is a signal, look for a broken/bad wire at the mics plug-in end. If no signal on the add-on meter, suspect an audio chip or final that's defective. All three are fixable at a GOOD CB Shop.

Dec 14, 2008 | Midland 4001 40-Channels Base CB Radio

1 Answer

Poor radio reception


you wanna boast up the radio signal?? There are ant. boasters around, But if your far away from a radio station your radio cant make that weak signal any higher in amplitude. All you would be amplifying is noise or static. Sorry

May 25, 2006 | Jensen VM9410 Car DVD Player

Not finding what you are looking for?
Creative Labs Zen Digital Media Player Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Creative Labs Audio Players & Recorders Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Carlos L. Burgos
Carlos L. Burgos

Level 2 Expert

618 Answers

yadayada
yadayada

Level 3 Expert

70374 Answers

Are you a Creative Labs Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...