Lost my instale disc for my monitor, it was instaled but due to computer break down, base came back but could not use my flat screen old monitor will work on computer but flat screen comes up with set computer to 1240+786 but due to not being able to find disc can not use this monitor please can you help me anne
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Technician (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you have a windows disc that came with the system, insert the disc while the computer is on. Shut the computer down. Turn computer back on. Your computer should boot to the disc. Delete partitions. Format the hard drive. And reinstall. If you do not have a windows disc contact sony to purchase a recovery disc.
I have just did this here is the solution for you:
Philips screw driver
Small Flat screwdriver
Make sure your desk is clean and you also need a piece of soft clothes because you need
to place your LCD Monitor face down.
How to open the back cover:
First, remove all screws on the back cover, then, use a small flat head screw driver to
the plastic Clip inside the LCD Monitor star at the bottom of monitor. Then you can easily
separate the front bezel and back cover like the photos shown below.
Backlight Inverter Installation Procedures for Dell W1700
Place the Monitor
Push This Plastic Button
Down and Remove
Swivel Base as shown
on Next Photo
Star at the bottom of monitor as
shown on photo.
Use a small flat head screw drive
to push down the plastic clip.
Do it one side at the time as
shown on next 2 photos
When you have unlocked all 4 sides of plastic clips, Place the monitor face down again
as shown on photo
left side of
Disconnect this cable and
remove back cover
screws and Pull
out this small
cable and remove
Remove these screws
on the both side of
Slowly tilt upward the chassis and disconnect the flat cable
between Chassis and Panel As shown on next 2 photos.
Holding the chassis upward and
Use small flat head screw drive
to unlock this plastic clip
Slowly pull it out
Remove defective inverter board and replace with our New Substitute Board
(T501045.00MSS) and re-install all disassembly components back. Now your LCD
Monitor working again.
MoniServ Substitute Board is available at
Backlight Inverter board.
Photo Shown with our Substitute Board