Question about Kitchen Ranges

1 Answer

OVEN KNOB REQUIRED FOR FAGOR 2H1261 OVEN - Kitchen Ranges

Posted by on

1 Answer

Fgfdg

Posted on May 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oven is off 100 degrees. How to calibrate it?


To Adjust the Thermostat


Pull the OVEN TEMP knob off the shaft. look at the back of the knob and note the current setting before making any adjustment. The knob is factory set wit the knob directly under the pointer.


1. Pull of the OVEN TEMP knob

2. Loosen both screws on back of the knob

3. Adjust lower screw so it moves in the desired direction. You will hear and feel the notches as you turn the knob. Each notch changes the temperature about 10 degrees F.

4. Tighten the screws.

5. Return the OVEN TEMP knob to the oven.


Re-check oven performance and make the necessary adjustments accordingly.


Feb 12, 2011 | GE Spacemaker JMS08 Electric Kitchen Range

1 Answer

How do i re ignite the pilot light


Hi

The surface on this range have standing pilots that must be lit initially. To light them:
1. Be sure the surface burner control knobs are in the "OFF" position.
2. Remove the grates and cook top.
3. Locate the pilot ports and light each of them with a match. Replace the cook top and grates.

Light the oven burner pilot in the following manner:
1. Be sure the oven control knob is in the "OFF" position.
2. Remove the broiler carriage.
3. Hold a lighted match at the top forward section of the pilot (See diagram). No adjustment is required.
4. Replace the broiler carriage.
Hope this helps...
Daniel

Aug 28, 2010 | Magic Chef 31000 Gas Kitchen Range

1 Answer

1. left front knob broken inside, cannot shut off gas to burner 2. Oven lights up but will not heat.


is font tap hard to turn if so would req. stripping &
greasing with a grathite grease.
as regard the oven you would require a new fsd.

Sep 28, 2009 | GE Profile Spectra JGBP90 Gas Kitchen...

2 Answers

My magic chef kitchen range oven won't turn on, no gas


Some of the models require you to push in the oven thermostat knob to set the pilot if it blows out. So try pushing in the knob and hold it while lighting the pilot. When the pilot lights continue to hold the knob in for about a minute. When you let go of the knob the pilot should stay lit. If it does not stay lit then try it one more time. If it continues to go out the thermocouple or aso might be bad and will need service.

Sep 11, 2009 | Magic Chef 31000 Gas Kitchen Range

1 Answer

Oven wont come obut igniter works


Yes, it could be the knob or the oven control.

If the knob fits tightly to the control, and turns the stem of the control, then I would be suspect of the control. But if the knob fits loosely, I would be suspect of the knob.

Jan 29, 2009 | Frigidaire FGF316 Gas Kitchen Range

2 Answers

Oven will not respond


The knob won't have any effect on the flame size.  The knob controls temperature.  If you're referring to the pilot light staying on and then the main flame not going on...that's another problem.  If the main flame will not go on, the assembly that controls the main flame is likely defective.  If the unit has a thermocouple, you might change it out first.  Sometimes, that's all that is needed and they're cheap.

Nov 23, 2008 | Rangemaster 110 (Gas) Kitchen Range

2 Answers

Philco Oven, Type: E60SM/ALIM400TC Mod:F650D4W The oven turns on ok some functions don't work, when finished with oven and turn the knobs off it continues to run. Have to turn off at the wall and only...


Many times the knobs get spun all the way around, and the adjustment screws on the backside of the knob, slide out of place. Try to "play" with knob, turn to a position where it will turn off. Turn off the breaker, and take the knob off, adjust the screws and you should be ok.

Jul 08, 2008 | Kitchen Ranges

1 Answer

Oven won't heat up to set temperature


IF THIS IS A GAS RANGE, AND IS USED ALOT, 4YEARS IS ABOUT THE LIFE EXPECTANCY OF THE IGNITOR FOR THE OVEN. IF THE IGNITOR IS WEAK, IT MAY NOT OPEN THE SAFETY VALVE. WITH A FLAT IGNITOR, IT REQUIRES 3.3AMPS TO OPEN THE VALVE. IF IT IS A ROUND IGNITOR, IT REQUIRES 2.8 AMPS TO OPEN THE OVEN IGNITOR.

IF THIS IS AN ELECTRIC OVEN WITH AN ELECTRONIC CONTROL, I WOULD SUSPECT THE OVEN SENSOR AS THE DEFECTIVE PART. AT ROOM TEMP, IT SHOULD READ ABOUT 1084 OHMS OF RESISTANCE.
IF IT IS A MECHANICAL CONTROL(WITH A KNOB) IT MAY BE ADJUSTABLE BY REMOVING THE KNOB AND INSERTING A THIN SCREWDRIVER UP THE SHAFT OF THE CONTROL AND TURNING A SCREW IN THE SHAFT TO CALIBRATE THE TEMP.

Apr 04, 2008 | Frigidaire FEF336BC Electric Kitchen Range

1 Answer

HOW TO TURN ON OVEN


I found an Ad with a description of the burner knob operation. Unfortunately I found nothing on the oven knobs. However, it's possible that the oven knob operation is similar to the burner knobs... * Dual burner operates by pushing in knob once for inside ring only (1,000BTU) and pushing in again to activate the outer ring (total 16,000BTU) Hope that helps!

Jul 30, 2007 | DeLonghi DEFSGG36D-SS Gas Kitchen Range

1 Answer

CAN NOT TURN ON OVEN


I found an Ad with a description of the burner knob operation. Unfortunately I found nothing on the oven knobs. However, it's possible that the oven knob operation is similar to the burner knobs... * Dual burner operates by pushing in knob once for inside ring only (1,000BTU) and pushing in again to activate the outer ring (total 16,000BTU) Hope that helps!

Jul 30, 2007 | DeLonghi DEFSGG36D-SS Gas Kitchen Range

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...