Question about Washing Machines

1 Answer

Kenmore wash macine

I have a Kenmore Hvy Duty 70 series model 110. Clothes Wash machine. The cold water fill starts flowing normally and within 1 min or 2 the cold water slows to a trickle. If I turn the machine off and back on, it flows normally and then slows again. I hooked the hot water line to the cold port and seemed to run normally with no slowing. I've cleaned the screens and the water hoses but continue to have the slowing cold water problem??????
Any ideas............?

Posted by on

  • 1 more comment 
  • Anonymous Mar 27, 2014

    but then the hot water enters and it's suppose to be a cold water wash. very little cold water enters the kenmore top load model 110 82683710

  • Anonymous Mar 28, 2014

    on selecting cold wash cycle when wash is started the tub moves but no cold water flows to the tub for the clothes to be washed in.

  • Anonymous Mar 30, 2014

    Have a 70 series and the cold water has been slowing down on fill. Now it is a trickle. No screen where hose connects to cold water. Hot and warm work perfectly. Can I fix it?l. Thank you, Mark

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 156 Answers

Its in your cold water line valve to the washer if it works good with hot water the valve are incoming line being blocked when you turn it on the pressure comes in fast then when pressure is gone water slows down so when its off the pressure builds back up it runs fast then slow

Posted on Feb 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Kenmore 70 series Washing machine top load model 110 serial number 82870120 . where is the lint trap located and how to take out to clean? clothes have a lot of lint after being washed.


It is likely that a tissue or paper product was included with the wash load. The series 70 does not have a lint trap. At the hose connection to the house drain lint has been known to build up restricting the emptying. This buildup would not introduce lint into the washer.

If the water temperature is very very cold and you use powder detergent it will not dissolve completely into the water and will leave a white residue on the fabrics.

Try running a short load in the washer allowing for ample water to rinse out the machine before the next wash load.

Dec 28, 2015 | Kenmore series 70 80 90 Washer timer...

1 Answer

I have the kenmore heavey Duty 70 series 92273100 Model 110 that we just moved. Was working fine before. Now it won't stop filling, overflows, and doesn't go into wash cycle. It will only s


either the pressure switch is bad or the pressure switch hose from the wash tub to the pressure switch is kinked or plugged so air pressure cant reach switch and operate switch,remove hose at tub and blow into it and see if machine now operates,if not the switch is bad

Feb 19, 2012 | Washing Machines

1 Answer

I have a top loading Kenmore Washing Machine. I don´t have the excat model but looks like a KENMORE HEAVY DUTY SERIES 70 AUTOMATIC WASHER, MODEL # 110.92273100. The problem presents after finishing...


You may have 2 defective parts.
First,make sure the hot and cold water hoses are connected correctly and both turned on.
If the water fill problem is the same,the water temp switch is bad.
The not filling after the wash cycle could be a bad lid switch.
Set the machine for SPIN and turn it on.
If it does not spin,replace the lid switch.

Sep 20, 2010 | Kenmore 24042 Top Load Washer

1 Answer

Kenmore heavy duty 70 series model 110-8237012


probably your drain pump leaking it has a seal right where it attaches to motor,,,,mine is leaking there but haven't replaced it yet! lol

Feb 27, 2010 | Kenmore Washing Machines

2 Answers

What is the capacity of my Kenmore 80 series Model 110 washer?


The cubic feet of the Kenmore washer model 110 heavy duty is 2.8 cubic feet. Measured to the top water line 14.5 inches and using the radius of the tub of 10.375 inches

Sep 08, 2009 | Kenmore 24032\24036 Top Load Washer

1 Answer

Slow to fill on most cycles, top loader. Kenmore washer takes forever to fill to the level needed to wash clothes.Model # 110 (92284800), Serial #CC0523352.


Turn off the water. Remove the cold water hose from the machine. Clean the sediment out of the screen on the water valve.You can remove the screen with a bent paper clip. Replace the screen after cleaning.

Aug 24, 2009 | Kenmore Washing Machines

1 Answer

Kenmore Series 70 washing machine whines and low flow on cold H2O


Yeah you need to replace the water valve. To get to it you need to remove the cabinet on the newer direct drive models, If yours has a rear access panel then you simply pop the top to get to the valve after removing the hoses. Fairly simple job. Here is a good website for direct drive coupling replacement . It shows you how to open the cabinet. http://repair2000.com/coupling.html
GVI 151 is the generic part that fix all belt drive models. Direct drive will need its own little water valve buy hay it ain't but 20 bucks.
For a better explanation post you model number in the comment box and I will research it further for you amigo.

Jan 20, 2009 | Kenmore 22422 Top Load Washer

1 Answer

Slow cold water only fill kenmore heavy duty 70 902202


remove fill hoses and inspected for debris or cloggs ,,,,

Dec 30, 2008 | Kenmore 22422 Top Load Washer

2 Answers

How to work my washer?


the timer change by itself. You don't have to change anything.
But cold rinse only works if you have the cold water connect to the washer

May 08, 2008 | Kenmore 24032\24036 Top Load Washer

1 Answer

Kenmore washer machine heavy duty 70 series


most likely a water pressure issue try adj shut off valve off slowly until noise stops if water flow not enough ckd fill screens in back of valve for sediment and trash

Apr 29, 2008 | Kenmore 22422 Top Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

462 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...