Question about Sanyo Xacti E6 Digital Camera

1 Answer

Black scrren camera seems fully functioning but only takes black photos and i cannot see anything through the screen in camera mode

Posted by on

  • alfabrizio Aug 01, 2008

    yes, same problem....black screen when in "still image" mode

  • judgeyb Oct 18, 2008

    Same problem with my camera - I can view pictures on the memory card but screen is totally black and doesn't take any new pics. Checked all the settings and they are as they should be. I couldn't find the relevant section on this problem in the link below. Any ideas out there, is it time to buy a new camera?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 103 Answers

Check out the following URL for help:  http://sanyoservice.com/pdf/images/VPCE6(OM)2.pdf

Posted on Aug 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Camera mode takes blank photos


Is the lens cover open? (Make sure battery is fully charged) go into the menu and reset the camera make sure it's switched to auto and try again. I assume you have looked at the photos on a monitor? If they are absolutely black with no noise it's the processor.

Apr 04, 2014 | Nikon Coolpix S560 Digital Camera

1 Answer

Hi Suddenly my g11 is blind lcd is working but camera doesn't see anything lcd is black in all modes like electronic courtain does not open exposing sensor all other functions are seems to be...


There is two ways to view your "taking picture" with the LCD and with the viewfinder, you can shut the LCD off to save battery power and use the viewfinder and that is what I think has happened. a touch of the DISP button and it will switch from the LCD to the viewfinder. here is a diagram

Diagram
tri3mast_209.jpg
With you saying the LCD is working for functions but not for taking pictures this is what I suspect is the problem.

Jan 20, 2011 | Canon PowerShot G11 Digital Camera

1 Answer

Black screen no image showing


black screen blur image showing cannot see subject to be photographed when camera power on,if press to take photo nothing shows, just black screen. it was fine one minute then nothing the next. battery is fully charged, memory card ok.

May 24, 2010 | Olympus FE-230 Digital Camera

2 Answers

Olympus Fe-4000 screen is completely black no image available


Stephan is exactly right. I have a FE-4000 and the LCD screen is most likely dead. As Stephan said, the screen should be replaced by a professional.

Cheers to all

dmklunk122

Dec 16, 2009 | Olympus FE-4000 Digital Camera

1 Answer

I cannot see anything when in camera, film, or view mode. When I snap a photo, it sounds like a picture was taken and the flash still goes off, but nothing is displayed on the screen. Only when I attempted...


Does it show pictures on the computer or is it black images, if they are black, your cameras lens cover could be stuck, it opens up when the lens is fully open, dirt-sand and dust or old grease causes the problem. otherwise your LCD on the camera could be off by mistake, (Do a camera reset) or a bad LCD

Oct 27, 2009 | Canon PowerShot SD600 Digital Camera

1 Answer

Panasonic DMC-TZ1 operates in Playback mode only


Hi,

The position from the dial wheel is not corresponding with the electrical position. If you can do it by yourself you can adjust it and tighten the midscrew from the dialwheel

Regards, Rob NL

Apr 20, 2009 | Panasonic Lumix DMC-TZ1 Digital Camera

1 Answer

LCD Black


sorry I have the same problem. It seems like it is a shutter problem...the shutter is locked closed therefore the screen is black.

Feb 25, 2008 | Konica Minolta DiMAGE E500 Digital Camera

1 Answer

Picture screen


This is an ongoing screen defact - Contact Kodak for a repair quote.e

Jul 17, 2007 | Kodak EasyShare DX7630 Digital Camera

1 Answer

Shooting mode will not operate


Your camera has a defective CCD imager. Please return the camera to Canon in New Jersey and they will replace the CCD at no charge to you. This is a known issue and should be covered under extended warranty. Good luck my friend. Joe Weibel customelectronics.org

Feb 27, 2007 | Canon PowerShot A75 Digital Camera

2 Answers

Lcd monitor screen stays black


there may have been some kind of damage to the lcd. sounds like you are going to have to send it in to have it fixed.

Jun 13, 2006 | Casio Exilim EX-S500 Digital Camera

Not finding what you are looking for?
Sanyo Xacti E6 Digital Camera Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sanyo Digital Cameras Experts

kakima

Level 3 Expert

96576 Answers

Tony

Level 3 Expert

2598 Answers

halotheracer
halotheracer

Level 2 Expert

68 Answers

Are you a Sanyo Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...