Question about Philips GoGear HDD1830 MP3 Player

1 Answer

Volume I have a mp3 GO GEAR SA3215 and the volume button doesn't work I can turn the volume down but can' t get the volume to go back up. I have reset and restored the mp3 it doesn't help.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 209 Answers

I'm not familiar with your mp3player but maybe check the Settings on Volume.

If that doesn't work and you can get the Volume to permanently stay up buy some Sony headphones with a volume control.

If you can't get it to work your last resort is bringing it back.

Good Luck.

Posted on Feb 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My volume button broke


1 Reset your GoGear with something sharp like the tip of a pen or the end of a paper clip, if you're device isn't working properly or there's a frozen display. Insert the sharp object into the "Reset" hole (located at the bottom of the player), and hold it there until the device turns off. If resetting the device does nothing to restore the display, access the "Philips Device Manager" through your computer to recover the GoGear.

2 Click "Start" on your computer, then "Programs," "Philips Digital Audio Player," "Aria Device Manager," and then "Philips Device Manager." This will launch the "Philips Device Manager." Make sure the GoGear is turned off completely. Connect your GoGear to your computer while holding down the "Volume Up" button. Continue to hold the "Volume Up" button on your GoGear, until the "Philips Device Manager" recognizes the device and enters recovery mode. Click the "Repair" button when it appears on your computer, then follow the steps to fully recover the GoGear. Properly disconnect your GoGear from your computer and restart the device.

3 Recharge your device if your GoGear dies suddenly while playing. Connect the GoGear to your computer via the supplied USB cord. Plug one end of the USB cord into a functional, open USB port on your computer. Plug the free, smaller end of the USB cord firmly into the small USB jack on your GoGear and turn your computer on. This will begin the charging process of your GoGear. If recharging doesn't work, the battery may need to be replaced. Check that your GoGear isn't in standby mode. Hold the "Power" button for two seconds to turn it back on.

Apr 17, 2012 | Philips GoGear ViBE Digital Media Player

1 Answer

The screen is frozen on the PHILIPS icon and when i reset it it did nothing, but when i put it on the charger then reset it, it starts charging, but when i take it off the charger it goes back to the...


Hi,

Please follow the below steps and check if that resolves the issue:

  1. Press down on and hold the "Power" button on your Philips GoGear MP3 player.
  2. Press down on and hold the "Volume Up" button on your Philips GoGear MP3 player. Continue to hold both of these buttons down for three consecutive seconds. The MP3 player will turn itself off.
  3. Press and hold "Power" until your Philips GoGear MP3 player turns itself back on. Your GoGear will no longer be frozen and you can use it as normal.
If you require further assistance then please revert back.

Regards

Anand Gupta

May 04, 2011 | Philips GoGear ViBE Digital Media Player

1 Answer

I have a coby kyros internet tablet mid7015-46 i bought it in november and it is stuck on android and will not move past that


By "stuck on android", the entire operating system is android. It is the Google Android operating system.
If the device cannot load up then it may need a factory reset. I am assuming like most android devices it has volume keys. If this is the case, turn the device off. Then, hold down the Volume DOWN button and keep holding it. Then turn the device on (still holding volume down). This will bring you to the recovery screen. From these selection, you can select using volume up and volume down. On that menu or one of the sub menus should be the option to do a data reset (factory reset etc). Select this option.
This will restore the device back to factory settings
WARNING: Doing the following will remove ALL data from the device, and MAY potentially stop the device from working. However, seeing as its not working at the moment anyway, you don't have an awful lot to lose!
Knowledge: HTC Desire owner (rooted) : Restored 10+ times with no errors

Feb 28, 2011 | MP3 & Digital Media Players

3 Answers

I cant turn volume up on my sandisk clip


My problem seems to be a damaged volume button. Once I tour the volume down (the down button is fine) I could not increase back de volume.
This is a palliative sollution. You need to reset you Sansa clip to get the volume set to the "middle" of the range. To steps are:
1) clique in the "home" button.
2) navigate to "settings"
3) select the "Reset All" option and confirm it.

Apr 02, 2009 | SanDisk Sansa Clip MP3 Player

3 Answers

Archos 5 frozen screen


I have found a solution for this issue, if you hold down the volume button and the power button for several seconds the Archos goes into a restore type mode. You then plug it into your computer and download the latest firmware update and cut and paste it onto the archos removable hard drive icon that appears in my computer. It will take a few minutes to update but then it will work perfectly.

Feb 03, 2009 | Archos Internet Media Tablet MP3 Player

1 Answer

My philips 2gb wont turn on


All of your issues may be hardware-related - call Philips to see if you are still under warranty. To narrow it down, try this:
Triple Reset for Philips’ GoGear:

Disconnect the Go Gear from computer. Press the reset pinhole until the player turns off. Hold in the volume + button, and reconnect the player to the computer while holding the volume + button in. Keep holding the volume + button for an additional 5-50 seconds. Windows should eventually go into recovery mode and revive the player- it will pop up a window that says Found New Hardware Wizard. If this pop-up does not appear, reset the player again WHILE connected to the computer. Open the Philips Device Manager, and go to Repair Tab. Reset the player one more time while connected to computer. Follow the repair instructions.

After repair is complete, upgrade the firmware for this player. Will erase all the songs, but you should be good to go again.

-Tha Mp3 Doctor

Feb 02, 2009 | Philips GOGEAR SA6045 MP3 Player

5 Answers

HOW TO UNFREEZE MY PHILIPS MP3 PLAYER


Hold down the off switch and press + volume at the same time

Jan 26, 2009 | Philips GoGear HDD6330 MP3 Player

1 Answer

It wont turn on!


Make sure the gold/lock is not engaged.

Triple Reset for Philips’ GoGear:

Disconnect the Go Gear from computer. Press the reset pinhole until the player turns off. Hold in the volume + button, and reconnect the player to the computer while holding the volume + button in. Keep holding the volume + button for an additional 5-50 seconds. Windows should eventually go into recovery mode and revive the player- it will pop up a window that says Found New Hardware Wizard. If this pop-up does not appear, reset the player again WHILE connected to the computer. Open the Philips Device Manager, and go to Repair Tab. Reset the player one more time while connected to computer. Follow the repair instructions.

After repair is complete, upgrade the firmware for this player. Will erase all the songs, but you should be good to go again.

-Tha Mp3 Doctor

Jan 22, 2009 | Philips GoGear HDD1830 MP3 Player

1 Answer

Want to know how to delete all the songs to start over again?


Triple Reset for Philips’ GoGear:

Disconnect the Go Gear from computer. Press the reset pinhole until the player turns off. Hold in the volume + button, and reconnect the player to the computer while holding the volume + button in. Keep holding the volume + button for an additional 5-50 seconds. Windows should eventually go into recovery mode and revive the player- it will pop up a window that says Found New Hardware Wizard. If this pop-up does not appear, reset the player again WHILE connected to the computer. Open the Philips Device Manager, and go to Repair Tab. Reset the player one more time while connected to computer. Follow the repair instructions.

After repair is complete, upgrade the firmware for this player. Will erase all the songs, but you should be good to go again.

-Tha Mp3 Doctor

Jan 08, 2009 | Philips GoGear SA3125/37 MP3 Player

1 Answer

Doesnt even come on


Make sure the hold/lock switch is not engaged.

Disconnect the Go Gear from computer. Press the reset pinhole until the player turns off. Hold in the volume + button, and reconnect the player to the computer while holding the volume + button in. Keep holding the volume + button for an additional 5-50 seconds. Windows should eventually go into recovery mode and revive the player- it will pop up a window that says Found New Hardware Wizard. If this pop-up does not appear, reset the player again WHILE connected to the computer. Open the Philips Device Manager, and go to Repair Tab. Reset the player one more time while connected to computer. Follow the repair instructions.

-Tha Mp3 Doctor

Nov 17, 2008 | Philips GoGear SA3125/37 MP3 Player

Not finding what you are looking for?
Philips GoGear HDD1830 MP3 Player Logo

378 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips MP3 & Digital Media Players Experts

Herby0802

Level 2 Expert

48 Answers

Pieter Vleeshouwers

Level 3 Expert

1423 Answers

mac colar

Level 2 Expert

421 Answers

Are you a Philips MP3 and Digital Media Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...