I would like to know how to reset an eflite 30 amp esc to factory specs. STOCK. ---no brake on--normal as it came new.

First of all you will need to remove the battery from your phone to turn it off for about 30 seconds. Now Turn on the phone and Check.
is it not working still? Then Press Volume up + Home + Power button and try to Wipe data/factory reset the verykool.
Still not working? Then we have to Flash Stock Rom again with Fresh Files. (Download new Stock rom and Smart phone Flash Tool)
Open the SP Flash tool Load scatter file and Flash your phone. after Flash give it to 2min because first time normally it is slow.

If it is a PC not an Android you will have to do a Recovery. Hold down ESC or f2 when you turn it on and go to (probably f10) for Recover to factory settings & follow directions

I’m happy to help further over the phone at https://www.6ya.com/expert/wynn_5ba0205233ebfc15

you must restart using HOLDING CTRL OR FN with f2 or esc depend of your mark of computer, they enter to BIOS now go tot reset factory defaulty, and ready.

God bless you

I have never had that issue in 50 years of doing brake work

You were given the dealership Dog & Pony Show as always

When you get a new vehicle the brakes are assembled dry at
the factory & rust on the train or car carrier

Like other vehicle parts they have to come apart,rust removed
& lube applied to all sliding surfaces & done at least once a year
on all vehicles

The same thing for spark plugs & trans fluid

30 days after you get it, you pull the plugs to gap them
& put anti-seize on them & change trans fluid to remove
the normal wear of bushings & debris you get when new

Your stove should be fine to install when the say 44.2 AMP that means that IF YOU HAVE ALL YOUR STOVE WORKING AT THE SAME TIME you will over load it, using as normal with 1 or two plates plus the oven should not cause a ploblem you have a FUSE system that will kick out on overload, enjoy your meal

sounds like a failty north chip not much to do about it somtimes the chip can cost more than the board mybe time for a new mother board used 10 pound from ebay new on ebay 30 to 40 pounds

dont need a code just get a toggle switch and hook that to the yellow/blue wire and with the other side ground to the small lil screw where you will see a small lil short wire and then all u have to do is fallow the screen with the e brake but just flip the switch 3 times with the whole one sec then off for 3 sec then on

Lower throttle trim all the way. It will arm like a charm.
Cliff

I would be very proud of that truck as the sub that came with the truck was only a 8". The only one that works is the factory model as it is a 1 1/2 - 2 ohm speaker; replacements are 4ohm. You will have to replace the amp as well if you put in an aftermarket sub. Oh and apparently the amp will have to have "speaker level" inputs as opposed to pre-amp inputs. I have a 1999 Eddie Bauer wih a blown sub and I'm trying to decide what to do as well. The speaker is $400 with tax in Canada! Good luck.

sensors on antilock brakes not picking up new info computer ob. must be reset to new specs on rims