Question about Car Audio & Video

1 Answer

Subs behind the rear seat in my crew cab

Does it matter if the back seat is pressed against the subs when i close it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,039 Answers

No if it bass only and as long as thet dont touch the cone of speaker

thanks for using fixya pierre





Posted on Feb 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jl audio subs


it may sound ok but that is personal preference..you will need to do process of elimination prior to your install and check your cabinets and mounts..dont want any vibrations you arent expecting..

Mar 04, 2014 | Car Audio & Video

1 Answer

Haw to gat out seat back


Rear Seat Backrest-SuperCab Removal
  1. Fold down both rear seat cushions.
  1. Remove the rear seat back.
    1. Push the wire hooks rearward to disengage the seat backrest from the back panel of the cab.
    1. Lift the rear seat back upward and remove.
    a0015238.gif
Installation
  1. Align the upper hooks with the upper brackets on the back panel of the cab.
  1. NOTE: Make sure the safety belt webbing is not twisted.
    Route the rear center safety belt through the retainer ******** the rear seat back.
  1. Place the lower hooks behind the lower brackets on the back panel of the cab.
  1. Lower the seat back until the lower hooks engage the lower brackets.
  1. Verify all three upper hooks have engaged the upper brackets

Feb 12, 2011 | 2005 Ford F-150

1 Answer

How do i get my spare tire down? special tool? where?


Hello! Here is procedure to remove spare tire...Guru...saailer



  1. Park on a level surface and put on the emergency brake. If the car is near the side of a road, switch on the hazard lights.
  2. Locate the tire repair kit. It consists of a jack, a jack rod and a wheel nut wrench. In the regular cab, pull the entire seat bench forward. The tools are located behind the drivers seat. The King cab model has a tool case located directly behind the driver's seat. The Crew cab stows the tools behind the back bench. Pull the bench forward and remove the tools.
  3. Insert the square end of the jack rod into the square hole in the nut wrench. This gives the jack rod a handle.
  4. Find an oval shaped hole in the back of the truck under the middle of the tailgate. Look through the hole and find the winch for the spare tire. It is a circle with two notches.
  5. Insert the T-shaped end of the jack rod into the hole. Slip the T-shape into the double notched circle of the winch.
  6. Turn the jack rod counterclockwise to lower the spare tire to the ground.
  7. When the tire is completely lowered to the ground, remove the center retainer chain and pull the tire out from under the truck.
  8. Wind the jack rod clockwise to completely retract the retainer chain

Dec 18, 2010 | 2001 Nissan Frontier Crew Cab

1 Answer

How to take out rear seats in a 2000 ford f250 lariat


crew cab,use a 50 torx in front bolts ,15mm on a ratchet on back bolts slide seat belt buckles throu seat crack ,fold rear of seat down ,lay seat with hinge toward floor slide out door (note watch brackets ,will scratch door pannals)

Aug 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

I have a sony explod an want to hook up the sub that came stock in my truck ( 04 chevy ss) its a bose sub. an dont want to run a amp, can it be done and how?


You can do it, but you'll need to use one of the outputs from the stereo, i.e. right rear/left rear. Disconnect the exsisting wiring to the sub. You'll need to run the two output wires from the stereo straight to the sub.

May 09, 2010 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Door locks on doesnt not have any power and want work , how can i fix that? Its on a ford f-150 model 2005.


This is not real clear to me, sounds like the locks don't work when pressing the lock side of the button ( as in the unlock works ). If so, the lock actuator is most likely the cause.

If this is the PDL do not have power to them, did you check fuses 6, 40, 18 & 107 ?
The PDL are controlled by the VSM ( Vehicle Security Module ) which these fuses are associated with it. If you have a door keypad, does it still illuminate when you press a button ?

If installed, and it does not, could be the connector to the VSM or the ground to it. The VSM is mounted on the rear cab wall, behind the seat back in the Super Cab and Super Crew cab configurations. There is a thread in here on removing the rear seat, to get to it.

Usually the problems seen with the connector are for the auto lamps, so I would suspect the ground wire ( seen this 2 times, not real common ).

Apr 20, 2010 | 2005 Ford F-150

2 Answers

15" Lanzar 400 watt sub


you would have to build a ported or sealed box with a sloped back

Sep 19, 2009 | Lanzar OPTI1222D Car Subwoofer

1 Answer

I love bass but cant find a good enough place to get a sub box in, were would the best place be???


i just pugt a 10" sub in my 89 k1500 regular cab right behind the drivers seat, sony, pioneer and alpine all make a box that doesnt affect how far back your seat will travel

Apr 16, 2009 | 1990 Chevrolet K1500

1 Answer

Unable to get rear set to lie flat and/or reach jack


it does not release the back of the seat it lets the bottom of the seat fold forward it is located at the pivot of the seat

Apr 15, 2009 | 2007 Chevrolet Silverado Classic SS New...

1 Answer

HOW TO INSTALL


I would say look for a custom box off ebay or build one behind rear seat. Im not shure if you can fit a small truck box behind there but you may be able to. It would sound pretty good behind rear seat. Hope this helps

Jan 13, 2009 | Pyle 12" 600 Watt Amplified Subwoofer Tube...

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4807 Answers

yadayada
yadayada

Level 3 Expert

70346 Answers

The Knight
The Knight

Level 3 Expert

72620 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...