Question about Pioneer AVIC-X1R CD Player

1 Answer

Not reading disc

When a cd or sat disc is inserted it says reading format but cant read disc is it repairable

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 199 Answers

Hi i have had a few cd's/DVD's repaired by blockbuster, they charge about 2 to 3 GBP and so far i have had no problems.

this works by removing a layer of plastic from the disc.

if this fails then it my be worth getting your unit serviced as the fans puill in a lot of dust from inside the car..


Mark
www.carradiospares.co.uk
www.blueice-electronics.co.uk

Posted on Feb 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have problem with reading cd why??????????? that dont read cd


check the cd you are trying to play if you have recordable cd some players wont read disk also make sure the cd has the right format example mp3 wave also try to use a disc cleaner if laser is dirty

plz comment reply if you need more info

Jan 19, 2011 | JVC KD-G120 CD Player

1 Answer

Getting disc read error


THere are a number of problems that can cause a disc read error. The lens can be damaged or very dirty. The motor that moves the les could be stuck or damaged. The disc could be dirty or scratched. Or the disc format might not be able to be read by the player. Do you try more than one disc? Are you trying different types of discs? like store boght discs and recordable discs. Some players wont read mp3 or cd-rw discs.

Jun 20, 2010 | Alpine CDA-7894 CD Player

1 Answer

My 1998 Jeep Cherokee cd player does not work, displays "error when cd inserted, the radio works fine, can it be repair?


it will read burnt cds, the only thing is that it will not play .mp3  format songs, if you can somehow change the format to something else it should work just fine. i had a friend who's car had the same problem and switching the file extension from .mp3 to something else like .mpeg or something else should work. the cd player in a 98 grand cherokee is older and does not have .mp3 play back on it so it cannot read .mp3 format files. that's the only reason it doesnot register. try different audi files out and it should work. give it a try. i hope that helps out some.

Dec 30, 2008 | Jeep AM/FM Cassette with CD Changer...

1 Answer

Alpine CDE-9841


Have one solution which might work.
Remove head display unit and press reset dutton usins a pin.
now connect head display unit. now insert CD. make sure the CD is in good shape.

Cheers
Alex Victor

Jul 26, 2008 | Alpine CDE-9841 CD Player

1 Answer

Error


The manual states 
1. " An (ERR_) message will appear, then change to a flashing (DISC), then the CD will be ejected." 
You will have 5 uninterrupted attempts to insert the correct CD.
2. After the 5th incorrect attempt, the display reads (HELP)
3. If (HELP) appears on the display, press button (6), then the (FUNC) button, and hold them for 5 seconds.
4. Press the (FUNC) button. You will have 5 more attempts to insert the correct disc.
IF AFTER 10 TRIES, AND IF THE CORRECT KEY CD HAS NOT BEEN INSERTED, THE DISPLAY READS (CALL 800); THE UNIT MUST THEN BE RETURNED TO ECLIPSE TO BE RESET. CONTACT ECLIPSE DEALER OR CALL (800) 233-2216.

Jul 19, 2008 | Eclipse CD3422 CD Player

2 Answers

Avic X1r will not read navi disks


I have had quite a few problems with copied discs not reading and it is usually the disc's but however in your case if you know the discs work on another unit then perhaps a later version of the discs were tested when the unit was repaired and therefore your earlier discs would not be recognised by the unit, and therefore your unit needs to be reset and i'm afraid this is not something you can do yourself, speak to northolt and see if this is the case.

Mar 15, 2008 | Pioneer AVIC-X1R CD Player

2 Answers

Problem with my kdc-4019


The most likely problem is the laser pick-up, it needs to be replaced. There are also a couple of other things that can cause this, but all of them are things that only a service technician can figure out. Things like the spindle motor, the DSP IC, or a defective voltage regulator. None of which are easy to diagnose without the proper test equipment, service manual with schematics and knowledge of how to troubleshoot electronics. I work at an authorized Kenwood service center and have over 18 years of experience repairing them myself, so I am not just guessing at this.

When the laser pick-up goes bad, it cannot read the disc. The very first part of the disc that it tries to read is the TOC, which stands for the "Table of Contents". If the player can not read that area of the disc, it cannot play any of the disc. That is where all the information about the disc is located. You can ask any technician who repairs CD players and they can verify what I have posted. Call a service center and ask to speak with a technician for a moment.

Most repair centers charge about $125 to $150 for this repair, depending on the labor rates of the shop and the mark-up of the part. The laser pick-up is the most expensive part of the whole radio normally.

I would be happy to offer you more help if needed. If you need a part number or even the service manual, I can email that to you (I have it in PDF format) if you have some electronics knowledge and want to do this yourself.

I hope this has helped you, and if so, a rating of "FixYa!" would be appropriate and very much appreciated. After all, it is the only reward we get for offering free help to people like yourself.

Dave

Feb 26, 2008 | Kenwood KDC-4019 CD Player

1 Answer

Pioneer avicx1


Nope, you have to have the CD in whilst entering a nav route, frustrating as it is...

You have to listen to your CDs via an auto changer.

Dec 22, 2007 | Pioneer GPS AVIC-X1 car radio

2 Answers

CDX-M8800 won't read CD-R discs


hi mate did you make the cd if so make the cd on slow speed it will work then max of 16x on you cd ok mate

Oct 19, 2007 | Sony CDX-M8800 CD Player

1 Answer

Every time i put a cd in it won't read


This indicated that the unit is having a problem reading the disc. This can be because the disc is upside down, dirty, scratched, misaligned laser, dirty laser. Try to reset and run a cleaning disc through the unit. If it still cant read it may be a mechanical issue stopping the unit from reading the disc

Mar 18, 2007 | Kenwood KDC-MP4028 CD Player

Not finding what you are looking for?
Pioneer AVIC-X1R CD Player Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Car Audio Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

xxxxxx xxx

Level 3 Expert

4706 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Pioneer Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...