Damaged LCD, Low battery LED on, wont comunicate with PC.

Remove battery. Maybe faulty? Try another cord/charger with the EXACT same specs. Reseat the Memory Mods. has the AC jack been damaged by pulling on the cord? Try plug in and at the laptop's AC jack "wiggle" the AC jack plug. Any change?

Try another outlet, another cord, has the AC jack been damaged due to a pull on the cord? If you wiggle the AC jack plug do you see any LED's blink? Battery charge Led come's on? Remove battery, reboot.

1.Check the device's battery level for at least two bars of strength.
2.If the battery level is low, charge the battery.
3.If the issue is not resolved, remove the back cover.
4.Remove the battery.
5.Wait 10 seconds.
6.Press and hold the W key.
7.While pressing down the W key, re-insert the battery.
•The device restarts and after approximately 15 seconds, the 'Recovery' screen appears
•Release the power button but *continue holding the home button*, for another 30 seconds.
Step
Thanks

Please follow the below steps. On this image "E" is the headphone and speakers jack. You can insert the speakers here.



Component Icon Description A. Speakers Provide audio output when headphones or amplified speakers are not plugged in. B. LCD panel release latch To open the LCD panel, slide the release latch to the right. C. Battery status indicator

• LED blue - battery is fully charged
• LED purple - battery is charging
• LED blinking - battery charge is very low

D. Power status indicator

• LED on - notebook is on
• LED blinking - notebook is in Standby mode
• LED off - notebook is off

E. Microphone jack Plug a microphone into this jack. The built-in microphone is turned off when a microphone is plugged into this jack. F. Headphone jack Plug amplified speakers or headphones into this jack. The built-in speakers are turned off when headphones are plugged into this jack

1) Ensure the cradle is plugged into an active AC outlet and the LED light on the cradle is on. There is a switch on the bottom of the cradle to control the brightness of the LED, set it to the highest. Try different outlets if needed. Does the LED light turn on and stay on (does not blink)?
ANSWER:
2) Remove the battery. Place the remote on the cradle and check the LCD screen. The LCD screen should display a 'White' screen with possible colors before going off. Try this a few times to confirm behavior. Did the LCD turn on briefly?
ANSWER:
3) Reinsert the Battery. Have you charged the battery for at least 3 hours? If no, please recharge the batteries for at least 3 hours.
4) Did the battery ever boot the remote? If yes, please continue troubleshooting.
ANSWER:
5) Remove the battery. Check the 3 gold contacts on the battery to see if there are markings on all the contacts signifying it was connected correctly to the remote. Did the battery have markings on all 3 contacts?
ANSWER:

I think There might Be Some Problem with Your RAM... just Check It out And Tell me

CHECK YOUR POWER CABLE

The operating LED will be blinking 5 times, means that there is a
comunication error (serial comunication) between the outdoor and the indoor unit.

when k800i is in battery low, infrared led will blink... try to charge your battery of buy another one.

there is no prblm in battery ur lcd has damaged pls ur lcd.