Power switch fell off & gone. Need new one

Need engine and transmission information for looking up a wiring diagram .

had the same issue. I found a replacement switch and it works for me. Make sure you place the wires in the new switch like the old.
http://www.ebay.com/itm/15A-250VAC-30A-125VAC-4P-Red-Indicator-DPST-ON-OFF-Snap-in-Rocker-Switch-/231064577698

E-bay under camera parts for your make and model.

A new fuse should fix the problem. Getting a surge protector plug can help stop this happening in the future (they're not particularly expensive).

if it fell apart Just get a new one and use the connector supplied with it ,, Once they give way they possess a danger better safe than sorry and the part isn't that expensive, heres the part for 16.00 and change !! http://www.partselect.com/PS346704-Whirlpool-3406107-Door-Switch.htm?inventory=346704&SourceCode=6

WHEN THE BELT CAME OF IT PROBABLY PULLED OUT THE PLUG THAT GOES TO THE SUPPRESOR HENCE NO POWER CHECK WHERE MAINS CABLE COMES INTO MACHINE AND FOLLOW IT THROUGH YOU WILL PROBABLY SEE IT DANGLING DOWN INTO THE CABINET MAKE SURE MAINS IS OFF BEFORE REFITTING IT.

your lid switch is gone! OK!!!!

Remove the two screws on each side of the head. Flip the head back, then see the clip where there are three wires? Unplug that! Now you can make a jumper if you want to save a few bucks. Using the 2 wires on the sides (the middle wire is a ground, and not needed for this jumper), from the part you just unplugged, strip them and join them together, protect them with a wire nut and electrical tape to prevent arcing, and now the machine will agitate and spin properly, even when the lid is up, so be careful if you have children about.

You can alternately buy a new switch and replace it. with the cabinet off the machine, unscrew the switch from the cabinet, and replace it with the new one (Don't cut the wires in this case, you'll need them here)

Best of luck on this repair
Joe

It is probably something like a 6365 and on all the Milwaukee products they have a switch wiring diagram but nothing for the switch. I would recommend going to a local repair center with the switch and match it up with a new one probably less than 15.00 If you give me your location with zip code I can direct you to the closest one. Let me know

Sure. You can even replace it with any momentary switch (Normally Off position switch) from radio shack or like places.

if you are good at opening the handset then just open the handset and adjust the display the screen correctly bcoz it will be in loose contact as it fall it might have became loose or the display might have gone one you open the handset and adjust it will work ...

once you press the display screen after opening the panel near edges and in the middle with a little pressure ...

if the display is gone then you can get the new display screen and you can replace that by your self it is easy to do it ...

the display screen of the 1100 is very cheap so no problem if it is gone means ...

if you are not good at opening then just take your cell to the service center he will do it but he may take some service charge ..

i think you can do it ,it is not so much difficult task ..

thank you
regards
-Dileep

rate my solution