Question about Hitachi 46F510 46" Projection HDTV

1 Answer

PANASONIC CT32SL13G - 32" TV

When I press the power button, there is clicking sound inside and scratching sound from the speaker but it won't turn on.

Posted by on

  • pinoy_eagle Feb 21, 2008

    I checked the board and I didn't notice any busted/burned part. Can you tell me which specific part might be the culprit? Do I have to test every single part to isolate the problem? and which section?

    Thanks

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,226 Answers

Hello:

There is some busted parts in your circuit board, you should examine the circuit for busted resistor and regulator. if afraid doing the task maybe you should let the repairman to do it for you.

May this help.

best regards melnavz.

Posted on Feb 21, 2008

  • Emelio Navaja
    Emelio Navaja Feb 21, 2008

    You should do continuity test coz there some part that unnoticeable but when it is tested shows error.



    Please refixed all the connection inside maybe some lossen connection that cause problems.



    PS. You should rate me so that YOur problem will be visible to some expert here in fixya.


×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My tv won't turn on when the on button is pushed, but the power light blinks 5 times


5 times LED blinks in Panasonic PT-47WX42 shows problem with convergence out chips failure as this tv has two big black ICs STK392-110 as convergence output, replace them to fix tv problem.

Jan 28, 2013 | Panasonic PT-56TW53 56" Rear Projection...

1 Answer

TV will not turn on-- clicking noise in the back


The power pack the the power cord goes into has gone bad and needs replaced, see manufacturer for service or parts.

Nov 15, 2007 | Panasonic PT-50LC13 50" Rear Projection...

1 Answer

Pt-47wx53g tv won't click over n than the power button will blink 5 times


IC4511 has failed on the DG board replaing the DG board as a unit i the only way to fix the issue. The DG board isnt serviceable

Jun 01, 2012 | Panasonic PT-47WX53 47" Rear Projection...

1 Answer

I have a panasonic projection TV, PT-60C13 that will not turn on. Upon pressing the power on button, the button flashes green many times, then flashes red five time then one orange flash. This red/orange...


Hi,

The most common cause of Panasonic Rear Projection LCD TVs not starting is bulb failure. The PT-60LC13 users manual gives some help in translating the LEDs on the front of the TV.

If the TV worked normally for a period of time (months or years) and won't start, the most likely cause is bulb failure. There is no way to measure the bulb, sometimes the bulb is visibly damaged when it fails. Remove the Lamp Assembly and look at the bulb.

If there was an On-Screen Lamp Replace warning and TV won't start, bulb has failed.

The first step with all Panasonic Rear Projection TV "No Picture" problems is bulb replacement. If that does not remedy the problem, get a technician, there are no user serviceable parts. Guessing if the ballast, power supply, controller board or optical engine is faulty is not practical.

The Panasonic Lamp Gallery shows all Panasonic models and Lamp Numbers. There is also a link to Panasonic DIY bulb and lamp replacement.

easyab

May 05, 2011 | Panasonic PT-60LC13 60" Rear Projection...

1 Answer

Panasonic LiFi model number PT-50LCZ70. Have red lamp light flashing on front 2 times. Have tried to turn it on and get no picture and no sound at all. I checked and the fan is running. What now?


After the red 2 flashing starts, press the power button on the front of the TV and hold pressed down for ten seconds.
You will hear a faint click comming from the back of set.
After 10 sec release the button and wait 10 more seconds then press the start button and release right away.
The green light flashes and the bulb attempts to start.
I found my picture will turn on on the third attempt of the bulb restarting.

When you do this and the room is dark you can see the bulb attempt to restart, My bulb has restarted on the third restart every time.

(note: The three start attempt happen after I do the button pressing
1 time and I do not need further button pressing restarts.

I think panasonic needs to let us know what the problem is.

I called Panasonic and they told me to plug it into a wall plug by itself.

I have it plugged into a multi plug adaptor now and have not tried this yet.

Nov 06, 2009 | Panasonic PT-50LCZ70 50" HDTV

1 Answer

My TV does not power up when the power button is pressed.


It's sounds like your lamp or backlight has went out, I suggest reading your manual for service info and look online for a local repair shop.

May 16, 2009 | Projection Televisions

3 Answers

TV Does not Turn on


it sounds like the power transformer maybe out on the set.it supplies power to the whole set and it sounds like it only getting partial power.

Jan 17, 2009 | Panasonic PT-52LCX66 Projection Television

1 Answer

TV does not turn on.


No sound means it could be a ballast issue. If there is sound, it could just be the lamp.

May 18, 2008 | Samsung HCM4216W 42" Rear Projection...

10 Answers

Projection lamp timer reset


I called 1800 211 PANA and they walked me through resetting lamp.
press recall and Volume- till solid screen shows, then hit recall till you see codes on top left, then hold volume- and mute(same time) till all codes return to 000000000000, then hit exit. turn off tv and check to see if it works

Jan 21, 2008 | Panasonic PT-50DL54 50" Rear Projection...

1 Answer

Fuse constantly blowing on 32" Panasonic HDTV Tau (ModelCT-32HL42)


Change fuse from F6.3 amp to T6.3 amp (Slo-Blo).

The problem is the surge of current at turn on.

 

Oct 10, 2007 | Projection Televisions

Not finding what you are looking for?
Hitachi 46F510 46" Projection HDTV Logo

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...