The volume screen for the monitor keeps popping up on the screen. how do i get it to stay off?

all switches on monitor needs replacing

hi,
while the system is turned on,
Remove all cables from monitor.
keep pressing the power button.
reseat the cables.
release the power button.
press the power button again to turn on the monitor.

It must work.
else the monitor needs repair.


Rate this solution and comment to keep in touch or further interaction

auto configuration menu stays on monitor screen constantly while trying to use pc for normaluse.

Sounds like one of the buttons on the monitor is sticking physically. Try:

• checking the buttons for dirt that might be holding it in
• cleaning the buttons with a soft brush

dirty switch. I took my 2009m apart and cleaned the switches with alcohol on a qtip and the problem's gone. Not too hard to do. Leverage the case gently with a putty knife or something and it will pop open. Then pop around the edge to remove the back completely.

Choose the auto adjust option

Was something spilled on the volume key? Sounds like it is stuck... you can use a fine toothpick and plain water to "scrub" around the key, there may be some buildup that inhitbits the key from "unpressing".

Hope this helps!

-- RT

Try putting pressure on the monitor near the buttons. There might be a short or some type of stress pressing the buttons.

no photos of said window presented? i cant see them?
must be OSD? the monitor brain on screen display (menu)?
even with the DVI cable pulled?
only a monitor stated, w1907, no PC
some monitors have button lock
read the manual ?oops HP deleted it...
it tells you to push the menu key on the monitor for 10 seconds
and it unlocks. (4 buttons right side left button is MENU)
doom?
that power deal sounds super bad, like the power supply is bad.
if the monitor fails by its self not plugged it to a PC
then the monitors is bad.
try a reset on it? ( power off for 1hr, or off then plug in with power button held? or power on with menu held (wild guesses but common practice)
ok found your manual page 4-8 shows menu page advanced
list line in list factory reset.
but if the keys are dead, and power lamp failing
the power supply is no good or worse. worse is always possible.
and expensive


ever see the support page, read the guides
?

https://support.hp.com/us-en/product/HP-w1907-19-inch-Widescreen-LCD-Monitor/3709665/model/3709666


its over 10 years old now. 2007?
walmart has larger one for $50
cheaper that parts or repair this.... vastly

Sounds like one of the front panel buttons is stuck in - possibly the volume down button. If no buttons work, this could be the reason why. Just a guess. If they all feel OK, it may still be worth pulling the back off, (Without electricuting yourself -DISCONNECT POWER!) remove the PCB board that has the buttons on it, and see if it turns on without the menu. If so, check all buttons, rare but I have seen one that looked fine but with a multimeter it showed it wasnt working. If the screen still displays the menu, Id say there is a bigger problem... HTH