Vertical size is too big I can not see the CNBC tape on the bottom and the markets on the top. Horizontal size is OK unit PDM-4210

on tube tvs bestto go on main bord look for hairline craks on soldering ok redo them nice it will light up happend to mine also older model thx nick

Click Start, Programs, Accessories, then Paint. to start Microsoft Paint.
First Method

1. Open the image file you wish to edit.
2. Click the Image Menu at the top and select Stretch/Skew Image.
3. Choose a percentage figure to resize the image. To avoid distortion, choose the same percentage for the horizontal and vertical stretch.
4. Click OK.
5. Once you have the desired size, click File, then Save or click Save As... to prevent overwriting the original image.

What you are describing can be due to a number of different settings.

Focus on the red and green guns
Sharpness on the red and green guns
Horizontal position and size
Vertical position and size.

Please consult a professional for adjustment on these items as they are all near or connect to parts that have Hazardous Voltage.

A frame has 4 basic frame sizes.1. Eye Size - refers to the horizontal width in millimeters of one of the frame's lenses.
2.Bridge Size - measurement is the distance in millimeters between the two lenses. It is measured between the two closest points of the two lenses.
3.Temple Size - is measured along the length of the temple, from one end to the other, including the bend.
4.Vertical Size (B) - refers to the vertical height of an eyeglasses lens, and is measured from the tip to the bottom of the lens aperture of the frame. The measurements are taken from a horizontal line intersecting with the top of the lens, to the horizontal line intersecting with the bottom edge of the lens. The B measurement is only important when ordering multifocal lenses; follow this link to read more about progressive lenses.

10 RED FLASH CODES

Symptom:
Unit appears to have poor convergence due to:
1. cross hatch appears tilted
2. one color (or more) being larger than the others.

Cause:
The yoke or yokes may have:
(1) rotated slightly or
(2) slipped down during transport.

Resolution:
Loosen a yoke and lower to inspect the tape. If black tape is present remove it from under all yokes (white tape or no tape is OK). Slide yoke or yokes up tight against the CRT and tighten to prevent slipping or rotation. Precede with
alignments and or convergence as necessary.

change the horizontal output transistor Big round quater sized thing on a heatsink. Next, posssibly the Capacitors are bad , will read 0 , big ones near the quarter sized transistor...

cut of 1/2 top and bottom, like vertical size sherink,
I replase vertical out IC stil same,
please repond your tips.

thanks

you just say horizontal lines / and across a top of your television.I expect your trouble is the vertical line of your television . sound ok? try trouble the vertical section the check the resistor?