How can i print using the PIXMA iP4500 ? Ink Jet Printer

change the power board and replace it with canoon ip4500

Check the black ink jet cartridge or replace as necessary.

Use warm water and a lint free cloth and clean all the ink around the cartridge area. I f that doesn't help I would try a new (not remanufactured) ink cartridge.

turn printer on and open front cover. carriage unit will come to middle of mch install printhead than ink tanks

6A00 is AP position error.First, make sure there is no paper jam anywhere in the machine.. look inside, rear, where the paper tray (output)
is, etc to see if you find any shreds or torn paper that may have gotten stuck and you didn't see.Look carefully in the zone of Purge unit, using flashlight in the right side on printer.If this not help your printer need service.

You need to try another cartridge before anything else, some generic carts. don't fit right in the printhead, the ink pad is too far up inside the cartridge. You may have a defective printhead, or possibly the purge unit is not cleaning properly. I can't tell without seeing the printer.

There are two black inks in the printer so that when you are printing only black and white such as printing a fax or when you set print in B/W for printed matter, the printer will use the larger ink cartridge. When you are printing in the multicolor mode (most people don't know the difference) the printer will use the finer black ink in the smaller cartridge. This smaller cartridge is used for photo printing and multi-color page printing. You cannot mix the two blacks since the larger cartridge is a coarser ink.

hi im josh in cebu phils. may i help you? Friend the problem is your cartridge and on the tank lever.it causes spoiled ink that stuck on it. To solve this problem. you may visit the Cannon Pixma support manual site and follow the steps there:here:
http://www.generalmanual.com/Printers/Canon-PIXMA-iP4500-Photo-Printer.htm

good luck friend hope i helped you.

Normal 0 Could have a corrupt driver.
Disconnect the printer or at least be sure it is turned off. I'd do both and when the CD software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud

GET ON TO YOUR GOV' REP AND KICK UP A STINK.
PEOPLE POWER. HEARD OF IT . DON'T EVER FORGET IT .
PETER