I have a shirlpool model lsr5132JQ1 top load washer. Unit will fill with water, agitate but will not drain water nor spin. Is this a problem with the switch or the transmission. I found no belt and thought that might be the problem. No funny noise, or any noise comes from the unit when switch is anywhere except adding water or agitatin. Thank you in advance for your help...

you need a new lid switch google model number and order new one

WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS THEN SPINS. STILL WON'T AGITATE please show me a diagram

Either the wire going to motor for non working speed is loose or damaged, or motor is bad. It could also possibly be timer not sending power to motor for that speed.

modle problem here its the main board common fault with this model good luck

If you have motor sounds after water fill,but no agitation or spin it could be a broken direct drive coupling. If it will not pump out water,there could be something stuck in the drain pump.

First, see the Sears parts site for your washer.

http://www.searspartsdirect.com/partsdirect/getModel!retrieve.pd?pop=true&modelNumber=110.23912100

Also see the Whirlpool (Kenmore) Service Manual for top load, direct drive washers.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/f7e2147fa98b28cf85257122007475cb/$FILE/L-55.pdf


The first thing I'd try is using a different cycle. If the washer works as it should, the problem points to the timer.

I'd also check to make sure that when replacing the switch, the connections to the timer haven't come loose.

Since you've replaced the Lid Switch, the motor has power for the drain and spin cycles.

These washers use a reversing motor. The motor turns one way for agitating and reverses for the drain and spin.

Since you cannot hear anything when it is supposed to be agitating, the problem does point to the timer or motor.

how to open top part of washer

Check lid switch. Most will not run with lid open and the switch may not be pressed down when door is closed

it sounds like a bad lid switch if it will not drain or spin,the switch controls that-mike

No agitation or spin in any cycle? If so and the machine will drain check the coupler.