Question about NEC Versa Heat VHE - 242 120 Volt Electric Five Power Spot Pedestal Heater !

1 Answer

Is there a 120 volt plug in on a dodge dakota to plug in a heater

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My pc on problam frist time on after shutdown after con't power on the ps

Posted on Jul 24, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I wire my pentair master temp

Bring in the proper voltage available, to designated wires and then "Make Sure" you use the correct plug 120 or 240 !!!!
This is an internal plug at the heater. A 240 plug is in place at time of purchase, if you only bring in 120 volts, then remove the plug and plug in the provided 120 plug.

Jun 16, 2014 | Pentair Mastertemp Heater

1 Answer

2002 dodge dakota truck right side headlight not working. Checked voltage and only getting 8 volts at headlamp plug. any ideas?

Could be worth checking headlamp relays for power drop on output side,if not try a check on headlamp earthing points...Good-luck..

Jan 05, 2013 | 1995 Dodge Dakota

1 Answer

Can you use a plug in timer to switch your storage heater on during the cheap rate electricity

Generally NO. Depends on amp rating of timer, wattage of water heater, and line voltage.
Look at label on side of heater for watts.
Electric water heater will work on any voltage.

1) Start with 120 Volt outlet::
Volts x amps = watts
Watts divided by volts = amps
Let's say outlet is 120Volts. Lets say water heater is rated 4500 watts.
4500 divided by 120 = 37 amps
There is NO plug-in timer rated for 37 amps.

Let's say water heater is rated 900 watts.
900 divided by 120 volts = 7.5 amps

Yes. The Intermatic HB113 timer will handle up to 8 amps.

2) 240 Volt outlet
Same calculations as above.

1900 watt element divided by 240 volts = 8 amp.
Yes, the Intermatic HB112 timer will safely handle that element.

3) Here are some water heater timers:

4) Here are some off-peak water heater ideas.

Oct 31, 2012 | Hardware & Accessories

1 Answer

First of all when trying to ingite gas heater there was a igniting sound but no actual ignition of heater and now when trying to inginte heater there is no sound at all of ignition. the brand is a Jandy...

if hooked up 120 volt make sure to turn the power conversion board plug to 120 volt come wired for 220 volt if you didn't the ignitor isn't heating up enough make sure gas pressure is good also

Jul 25, 2010 | Jandy Laars Lite2 Ld 400,000 Btu Heater

1 Answer

97 dodge dakota. Tried to replace the heater

There is some wire shorted to ground during the dash work due to some pinched points. Need to revisit the re-installation work.

Dec 12, 2009 | Dodge Dakota Cars & Trucks

1 Answer

I have just replaced the heater core in my 98 dodge dakota and my speedometer is stuck on 120 what shall i do

when you had the dash on its way out it got tilted and the free moving hand in the speedometer floated around the ring,
now you have to remove the cluster and hold it up side down to get the needle to float back to the other side of the stop pin.
or, drill a small hole at the base of the speedometer and take a piece of wire to move the needle,
good luck

Nov 22, 2009 | 1998 Dodge Dakota

1 Answer

Own dodge dakota 12 volt aux power supply quit working and it shows no fuse for this do u have any suggestions

check all fuses for a bad one or the plug could be burt out had to replace mine its a cheap part

Jul 05, 2009 | 2003 Dodge Dakota Club Cab

2 Answers

Electrical wiring for 120/208 service as opposed to 120/240 service

Your machine requires 208-240 volts to operate with each leg being about 120 volts. Move refrigerators are 120 volts so even though you have 20 amps you probably only have 120 volts.

You can go to the Bunn website ( click on Commercial then on Publications then Illustrated Parts and Service manuals and download the manual for your machine that shows how the wiring hooks up in the machine and the type of cord the machine requires to handle the voltage.

The plug you need must match the receptacle in the wall and there are numerous 220volt plugs and receptacles on the market. Don't get a dryer plug instead try for a twist lock as they are more reliable.

Oct 21, 2008 | Bunn CDBCF 35 Coffee Maker

Not finding what you are looking for?
NEC Versa Heat VHE - 242 120 Volt Electric Five Power Spot Pedestal Heater ! Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top NEC Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1339 Answers

Bill Jordan

Level 2 Expert

372 Answers

David Spradling
David Spradling

Level 3 Expert

5062 Answers

Are you a NEC Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides