Question about Rinnai Toyostove Direct Vent Heater: Toyostove Laser 73 Shipping

1 Answer

Visible flames Flames are licking out of the grates on Rinnai Tropic heater.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Hello. This problem is a fire hazard. Phone your gas provider and tell them to send out a technician as it appears that your gas pressure is too high. This is a free service. Regards, Joe
PS - kindly rate my answer. thank you.

Posted on Feb 02, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Rinnai Tropic wall unit heater makes noises after the thermostat cuts off the heat and it's cooling down. Then it makes a loud clang sound. What's goin on please?


Jack some of this normal due to thermal expansion and contraction. If you installed it, you should check all the fasteners and make sure they are tight.

Nov 28, 2016 | Rinnai Heating & Cooling

1 Answer

What color should flames be on a portable heater


no flames should be visible.... but if it is... then blue

Jan 10, 2014 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

Evening, Rinnai Convector 417 - the two flames on the right hand side panel are on - heater tries to light but switches off before igniting we have cleaned the filters - seems to be no spark


There are about 8 reasons why this is happening. Rater than going into each and every one, I have included a link to an Owners Manual, that under the Troubleshooting Sections (pages 12 & 13) it will provide you with the scenario and how to solve the problem. This manual may not be the exact same one as your heater, but they all work the same and have the same problems.

http://www.rinnai.us/documentation/downloads/RHF265-1091X0101_202FTA_265FTA_Manual.pdf

Hope this helps you to further troubleshoot and solve the problem.

Apr 27, 2011 | Rinnai Heating & Cooling

1 Answer

I have three Kozy World wall heaters. Two work just fine - the bricks turn red after the heater has been on for a while. The third one always burns blue and the flames 'lick' the top of the inside of the...


Yes, it sounds like the third heater has a Control Valve problem. It's allowing more gas into the system than what it's supposed too. Have you tried turning the flames down to a lower setting? If so, did it lower the flame height? How old is this heater and is cleaned and serviced at least annually? Are you using Natural Gas or Propane?

Please get back to me with the answers to the above questions and I may can help you.

Thanks,
Rich

Feb 07, 2011 | The Companion Group Kozy World Portable...

1 Answer

What colour should your gas heater flame be


Hello,
It should be blue. If it's got orange tips, it's burning dust, If it's got yellow flames or tips, it may need the air shutter adjusted, regulator pressure adjusted, the vent unblocked or just a real good cleaning. Douglas

Jun 05, 2010 | Rinnai RHFE-1004FA 38,400 BTU Energy Saver...

1 Answer

New heater has worked but now lights up then immediantly goes out


There should be a flame sensor similar to the one below. The tip will be directly in the flames. Try cleaning that with a piece of steel wool and try the heat again.
2009-12-02_202151_flame_sensor_clean.jpg

Mar 24, 2010 | Rinnai RHFE-556FAIII 21,500 BTU Ductless...

1 Answer

1600c vanguard propane heater, big flame on middle grate


Make sure the grate is in the holder like the others, and nothing is blocking the bottom of it. They often slip back where the fire misses the inside where it should hit.

Dec 22, 2008 | Vanguard International Infra Red - Large...

1 Answer

Pilot lights but when ignition pops back up the flame goes out


will either be the unitrol control box or the thermocouple, when you push down you are holding two magnets together and waiting for a small charge to be created from the probe in the flame , if this is not working you have no charge and the magnets won;t stick to allow the valve to open, change the thermo and see if that works first, its way cheaper than a new controler

Nov 25, 2008 | Rinnai Desa Vent-Free Infrared Gas Heater:...

Not finding what you are looking for?
Rinnai Toyostove Direct Vent Heater: Toyostove Laser 73 Shipping Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rinnai Heating & Cooling Experts

paulcarew

Level 3 Expert

2457 Answers

blender719

Level 1 Expert

53 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Rinnai Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...