Question about Humidifiers

1 Answer

Humidifiier humidificateur I had an Humidifiier installed on my furnace 2001 at that time they installed a huidifier model he260a1002 It has stopped working and I do not have any instruction do you have any for this model Leo Hunt huntink@peoplepc.com

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Try going to Honeywell.com

Posted on Mar 04, 2008


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring a humidifier to a furnace


Why not contact Honeywell for explicit instructions for installation which should have been included with the HE240? Also, if the old humidifier was installed in the return duct of your Rheem furnace, the new one should be installed in the main distribution duct.

Nov 11, 2013 | Honeywell HE220A1019 Whole House...

1 Answer

My lennox furnace works just fine except that 25% of the time the fan keeps running when it shouldn't and blows cold air


You are using too restrictive of an air filter. If the codes you are getting off the lights says anything about a high limit this is the cause of your blower running all the time. Use a less restrictive filter or have your contractor install a media filter in the system. if you reset the furnace and it does not stop running the blower you have a stuck limit switch and may have to get another or call a service tech to reset it or replace.

Oct 27, 2013 | Honeywell Power Humidifier: Furnace...

1 Answer

I hooked the humidifer up and water keeps running it dose not stop when furnace stops. What might be wrong?


Hello, this could be tw o different things. when you install a humidifier you need a means of turning it on and off with the furnaces blower motor, this is done by either a sail switch, current sensing relay, or by the transformer being hooked up directly to the furnaces control board. if you do not have one of those three than the humidifier will run continuously untill u manually turn it off at the humidistat. If you have one of those three installed already than the solenoid valve is stuck and must be replaced.

Feb 08, 2011 | Honeywell HE220A1019 Whole House...

1 Answer

I think this the model i have . The problem i have is the fan keeps running. Before once the furnace stopped shortly after the humidifier fan would stop . Now it just runs. I tried unpluging it to reset...


I think what your saying is the humidifier runs continuously. Check the wiring diagrams on the back page of the installation instructions.
You may have to install a sail switch to control the humidifier so that it only runs when the furnace blower runs (there are a couple of other ways to do this, but on older furances, this might be the easiest (it's the method I chose).

Nov 30, 2010 | Honeywell HE360A1027 Whole House...

1 Answer

Aprilaire 600 humidier: water continuously runs


sounds like you may have it wired to a continuous power source vs one that shuts off with the furnace. The most common wiring is red to C & white to W

Jan 08, 2010 | Aprilaire 600 Humidifier

1 Answer

Honeywell HE260 leaks somewhere


Neither, even if the solenoid or humidistat stick, it should always drain properly. Is the unit mounted on the cold air return duct or the supply plenum? If it's mounted on the supply plenum, the water panel might be getting blown forward and spilling the water. High efficient furnaces also can leak water on the floor if its drain is restricted. If hum. is mounted on return duct make sure drain is clear by blowing through it. On Honeywell hum's I've seen the rubber hose from the solenoid valve to the distributor tray leak too, check the rubber 1/4" hose.

Dec 28, 2009 | Honeywell HE260A1010 Whole House...

1 Answer

Water runs when furnace is off, but stops when furnace is on.


the 760 humidifier does not need a transformer wired externally. the 760 has its' own 24v transformer inside the fan compartment. this transformer will provide the power to enrgize the water solenoid as needed. it sounds like to me the additional trasnformer is hot all the time. when the furnace comes on, the unit gets power and the internal transformer is cancelling the power from the external transformer. this would explain why it quits running when the heat is on. since the external transformer is hot all time, when the heat shuts off, the solenoid is getting energized by the external transformer. to make this run correctly, you need to get rid of the external transformer. leave the humidifier high voltage wires hooked up so they are only hot when the furnace runs. if you have a humidistat that has a r and c terminal, you will need to wire these directly to the r and c on the furnace control board and move the switch inside the humidistat to "power". make sure it is not on "bypass". then wire your 2 brown wires from the humidifier to each of the "h" terminals on the humidistat. if you have a humidistat that only has 2 terminals, wire one brown wire to each of the terminals. this should allow it to run properly.

Jan 28, 2009 | Aprilaire 700 Humidifier

1 Answer

Fan shuts off too soon after oil burner stops


That is an old style t-stat i would replace it with a more up to date model. Your problem may be in the limit switch. But yes to answer your question most fans can be adjusted just depends on if it has a manual limit that looks like a silver box on the interior of your furnace or if it has a mother board control system.

Jan 04, 2009 | Honeywell Power Humidifier: Furnace...

2 Answers

Loud "Glonk" when humidifier turns off


Try turning the water valve going to the soleniod down. There may be too much pressure. You may have to replace solenoid one more time after making the adjustment.

Mar 12, 2008 | Aprilaire 700 Humidifier

1 Answer

Honeywell Chronotherm III


Try this link:

http://yourhome.honeywell.com/yourhome/Applications/TechLit/TechLitSearchResults.aspx

It looks like there are a variety of model numbers for the Chronotherm III. Hopefully you can locate your model number.

Dec 17, 2007 | Honeywell Power Humidifier: Furnace...

Not finding what you are looking for?
Humidifiers Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Humidifiers Experts

paulcarew

Level 3 Expert

1863 Answers

Mack Baxter

Level 3 Expert

379 Answers

Ken Thomas

Level 2 Expert

118 Answers

Are you a Humidifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...