Question about Nintendo Wii Remote Controller

1 Answer

Im pressing 1 and 2 witch start it up but its not connecting

Posted by on

  • gentrygailan Feb 01, 2010

    that didnt work at all

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Press and hold then for about 15 seconds.

Posted on Feb 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Are there more than 1 way to turn on a Sony Xperia go


there is three ways:
1- the normal way (by pressing the power key or connecting the charger normally)
2- Flash-mode (by pressing and holding the volume down key and connecting the phone through a usb cable and keep holding the button until the phone led goes green)
3- Fastboot-mode (by pressing and holding the volume up key and connecting the phone through a usb cable and keep holding the button until the phone led goes purple)
there is a forth extra way to boot but you have to manually install it first witch is :
4- Custom recovery boot: (by repeatedly pressing the volume down key immediately after pressing the power key to tern the phone on until it loads the recovery) (why do I need to install it? because the sony xperia phones come with no stock recovery so you must install a custom one)
Hope I helped and don't forget to hit thanks!

May 02, 2014 | Cell Phones

2 Answers

My deut gas dryer will not start the panel ligths work. i have tested all switches they ohm check good just replaced my control board this did not fix my problem


On the blower housing behind the lint filter is a white thermal fuse. Or below the motor is a belt switch that maybe bad. Also remember electric dryer work on 240 volts sometimes you may lose 1 leg of that and have 120 going to the dryer, witch is enough to power the lights but not run the dryer.

Mar 08, 2014 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

I have a kia spectra ls 2002 it doesnt ref right and loses alot of power i have removed the sensors in the exhaust then it refs right iv even put them back and removed the the exhaust from the manufold and...


Hi wesley
Your Kia seems to have a blocked exhaust
probably is the catalyst witch causing the problem
you need to have the exhaust check
good luck

Jan 18, 2014 | Cars & Trucks

1 Answer

Emergency cable connected but still dont work


i cant get my data connection to work on my phone i click the button to turn it on says turning on and then it just doesnt work, which means i cant use my phone when im oout and about unless i am connected to a wi fi witch most the time i cant get wi fi when im out with friends can someone help me how to get it to work again


Mercedes Superchargers

Jun 13, 2012 | 1998 Chrysler Cirrus

1 Answer

2006 Navigator air bag light is on, code 42, any thoughts?


The information that is on my screen can't be correct. This is an OBD 1 code thats an O2 sensor to rich dose not switch . The screen says it is a 2006 witch would be an OBD 11 system witch olny reads 4 digit codes. Im not sure of the information mabey the incorrect year posted

Jan 18, 2011 | 2006 Lincoln Navigator

1 Answer

Im trying to wire an amp remote wire huh


the blue or blue with white wire. 1 is for the amp and the other is for a motorized antenna try either 1, you can not short any thing by hooking up the wrong one

Apr 25, 2010 | Car Audio & Video

1 Answer

Front panel connectors


hi im wesley. ok the power and audio connecters is very simple if you look at the bottom right of the motherboard you will see you can plud them and it says the name of witch is the power and witch is audio and it doesnt realy make a difference witch way you put them in just as long as they are on the right pins. the usb might be a little more tricky unless it says witch connecter is the usb 1&2 then its the same as the power led but if you dont come right i will try to get a diagram for you or draw one up but it might not be as accurate tho as i do not own a asus motherboard but i will do my best.

Jul 11, 2008 | ASUS P4S533-VM (P4S533-VM/L) Motherboard

1 Answer

Please help


Need more info: You indicated that you moved. 1. Did you change internet service provider? 2. DSL or Cable Broadband? 3. If DSL, what type of modem? This info will help paint a better picture of the problem.

Sep 25, 2007 | SMC Universal Wireless Broadband Router...

Not finding what you are looking for?
Nintendo Wii Remote Controller Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nintendo Video Game Consoles & Games Experts

Bee Santiago

Level 2 Expert

268 Answers

Raj Patel

Level 3 Expert

916 Answers

Martin Murray

Level 3 Expert

1623 Answers

Are you a Nintendo Video Game Console and Game Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...