Halfway through self clean the F 10 error button light comes on.

Useless website, but my advice is to never use the self clean option. It always breaks things. Disconnect the power at the breaker for 10 minutes.

Help category: Error code / error display / signal

Problem: Other error code, error signal appears on the display

Select another help category
The buttons on the control panel are dirty or jammed. Cause
The buttons on the control panel are dirty or jammed. Resolution
Press all buttons. Clean the control panel with a dry cloth. Open and close the appliance door.

might need to run it through the cycle again. you may have disrupted the timers and if has not reset itself. try this link and see if these answers help you out.

Why does my oven light keep blinking after the self cleaning cycle on my...

Just don't use it. The finish in the oven is made to work with the self-cleaning operation; it naturally facilitates burn-off at high temperatures. It is normally impractical to remove and replace the finish, besides, it's harmless as far as I know. If you are worried about someone accidentally activating self-clean, you could tape a coin over the self-clean button. (If you have a curious child in mind, the coin may actually draw attention to the button and invite its operation - you know better than I who or what you are dealing with.)

There is no good way to disable the self-cleaning function without replacing the controller with a custom-built and programmed unit. The button is in a matrix with other buttons, so attempts to disconnect it would disable other buttons and generate a controller error that would prevent the range from operating.

This is what I used on my Kitchenaid Superba maybe it will work on yours also.
Hold the "oven light"
then push the "CLEAN" button
and then the "START" button.
Wait until "Door Locked" shows on screen.
Press "Cancel/Off" (Upper Oven) wait until "Door Locked" turns off.
The oven F5 E1 is now fixed.

Hello,

The F5E1 error codes means that the door light switch OR a switch on the self clean latch has failed. If the oven light comes on and goes off when the door is opened and closed it most likely going to be a switch on the latch thats the problem.

The part numbers are;

DOOR LATCH W10107830

LIGHT SWITCH 3195993

GENE

Error code F2 on clean cycle is indicating that the maximum permissable cleaning temperature has been exceeded. (or it's got too hot!)

However it seems unlikely that that would happen in just 10 mins. more likely it is a problem with the oven temperature sensor which should be checked over as should the lock switches..

a maid used easy off oven cleaner and my enmale came off . how can i fix this

The F9 code indicates there is a problem with the door lock.

Try disconnecting the power to the range for 10 seconds and reconnecting. Open the oven door and hold the door switch plunger in while you try these things. Put the control into clean for 5 minutes then cancel clean. You must hold the door switch plunger in for the 5 minutes.

Try canceling the clean cycle without putting the control into clean.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question^%$%^@#

I can't help with the burn marks, but have considerable experience with the F7 problem. Click on the following link for my solution:

http://fp1.centurytel.net/Powerman/Dreaded%20F7%20Problem.pdf

I have now shared this with over 1400 folks and most report success. Please let me know if this works for you.

You can email me at [email protected]