Question about Duravit 0910100005 Happy D Toilet Cistern - White

Open Question

Recurring toilet leak on starck 3 close coupled

The bendy chrome pipe which water goes through to refill the cistern after flushing started to leak a little a couple of months ago and water eventually found its way through the boxed in tiling at floor level. The toilet was loosened and pulled forward to allow a new chrome pipe fitting to be attached.This was a longer version of the pipe to make it easier to slide the toilet back into place.
Last night noticed water again at floor level and when I looked inside the cavity where the feed pipes are could see water has leaked again.The chrome fitting is as far as I can see still attached and the loo is flushing as usual.I am assuming this fitting is working its way loose and creating the problem allowing water to escape.I dont understand why this should be? Any comments or suggestions most welcome.Thanks.The product is Duravit starck 3 close coupled toilet

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: cannot remove top of cistern

There are some dual flush cisterns where you have to depress one button to reveal a cavity in the second button. Put a screwdriver in that cavity to lever out the second button, then release the first button and prise that out.

Underneath the buttons is a screw which must be unscrewed to release the cistern lid.

Not sure if this will apply to you... but if not, good luck anyway.

Posted on Jul 02, 2010

Ad
  • 67 Answers

SOURCE: Have a Duravit Starck 3

Unfortunately you won't find a universal replacement part to work with this seat which you would commonly find at your local hardware store. I've looked through the Durovit site and could not find a parts catalog. Try using the find retailer option on the manufacturers site and if there isn't a retailer in your area contact the manufacturer directly to see if they supply parts for their seats. I'm guessing they don't and you would likely have to purchase a new seat.

http://www.duravit.com/service/find-a-retailer-useo6suuk8.html
Duravit USA, Inc.
2205 Northmont Parkway
Suite 200
Duluth, GA 30096
Phone +1 770 931 3575
Toll free: 888 387 2848
Fax +1 770 931 8454
Toll free: 888 387 2843
info@usa.duravit.com

Posted on Aug 02, 2010

  • 32 Answers

SOURCE: I removed the lid from my Duravit cistern. I

the botton should adjust up and down by tuning it left or right

Posted on Dec 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a leak coming through my ceiling from the ensuite toilet above. It is an ideal standard wall hung with concealed cistern behind tiles. There is no obvious access panel. The tiled wall is flush.


The flush control panel normally comes off. You can then hopefully see inside. You won't be able to see much though as the cistern will be in the way...

Places to look for leaks are:
Soil pipe to pan
Cistern to flush pipe
Flush pipe to pan
Cistern overflow.

Apr 17, 2017 | Home

Tip

FIXING A TOILET THAT WILL NOT FLUSH!!! a simple but very effective money saving...


This simple how to, is based upon most lever operated toilets, with the cistern mounted above the toilet bowl. The make and model of toilet used for this feature is of the following:
Toilet and internal syphon
DUDLEY ELITEDudley S7 Cascade syphon
Problem:
My toilet will not flush, but the ball float valve is working and there is water in the cistern; no leaks present and the flushing lever is not broken or disconnected, what do I do?
Answer:
first isolate the water to the toilet or the main water supply to the house. Bail out the water from the cistern using a small jug or cup, (or you can syphon the water manually using a hosepipe or similar pipe, a towel to cover your mouth, and either a bucket or the toilet bowl) and remove water from the bottom of the cistern with a sponge.


Changing the syphon in a toilet that is not close coupled is far easier as you do not need to remove the cistern from the wall!


Undo the lower of the two large nuts beneath the cistern using a large pipe wrench or pair of water pump pliers, now disconnect the flush pipe and push it to one side.
Place a bucket or bowl beneath the cistern and undo the Nut which is immediately below the cistern (syphon replacing nut), some water may be released by the syphon, take note of any washers that are removed as new ones need fitting when replacing the siphon.
Unhook the lift rod from the flushing lever and remove the syphon.


Inside the toilet syphon, there will be a small plastic piece of sheet called a diaphragm; you can fabricate a replacement using the plastic title cover on a DVD case. Cut this to the exact same size and shape as the original part, and fit this to where the original diaphragm was. This is your new replacement.


Refitting is a complete reversal of removal, be sure to fit any washers (preferably new ones) that you have taken out. Ensure everything is tight but do not over tighten before refilling the cistern



on Aug 09, 2010 | Plumbing

2 Answers

My toilet flushes, then the water in the bowl drains over 4-5 minutes resulting in sewer gas smells.


Look inside the tank under the lid, it sounds like the flapper that lets the water into the bowl is getting hung up on something when you flush. It could be the flushing lever. This would cause the flapper to stay open letting water to just pour into the open sewer line. It should be a simple fix. Just see what is binding the flapper & make an adjustment.

Dec 02, 2015 | Duravit Starck 2 One-Piece Toilet

1 Answer

When I flush my toilet I get a Foghorn sound for a few seconds what causes this ?


sounds like its the water rushing in to refill the tank try closing the fill valve just slightly to slow the water down

Apr 27, 2015 | Home

3 Answers

MY TOILET FLUSH VALVE SEEMS TO BE CLOGED BUT I CLEANED IT IT WILL FLUSH BUT WONT FILL TANK YOU CAN HEAR WATER WANTING TO COME OUT PLEASE HELP


Hi Juan
Unfortunately we can't see what you can see. The problem must be right in front of you but you are missing it. Eg Parts / Seals in backwards.
If you can't figure it out and it's that urgent then call a plumber.
Good Luck

Nov 02, 2014 | Home

1 Answer

How do we Stop leak down side into water in the bowl between flushes?


is it a close coupled toilet? as it sounds like you need to change the doughnut washer between the pan and the cistern.

Aug 30, 2014 | Home

2 Answers

The toilet cistern is filling up but the toilet pan is not getting enough water presure to empty


check that the water in the cistern is up to the mark etched on the inside
Do you have a close couple or a washdown [with pipe from cistern to pan]

Mar 04, 2010 | Home

2 Answers

My toilet cistern is continually hissing


Hi I have exactly the same problem, in fact it could have been me writing this - 3 toliets fine, main bathroom hisses. The Geberit flushing ciphen on the left (the smaller one) has been replaced and there is still a problem. If you look carefully,the water level needs to come up over the lip of an opening on the Geberit part and this causes the valve mechanism to shut off and stop the hissing. It is fine for about 40 minutes and then the hissing starts again if you don't flush it. The reason is that the water level has gone down but there is no obvious signs of where the water is going. It could be that the central flush mechanism is leaking slightly. I am going to replace this part next. If I were you I'd see if you are getting any water leakage into the pan when toilet not in use to see if the water level in the cistern is going down James T

Oct 17, 2009 | Duravit Starck 3 Wall Mounted Toilet with...

1 Answer

Running water in Geberit Starck Toilet


I hate to say it but you may need a pro on this one, if you want I can try to walk you threw it but let me know. bigslimaba@yahoo.com

Jan 11, 2009 | Duravit Starck 3 Wall Mounted Toilet with...

Not finding what you are looking for?
Duravit 0910100005 Happy D Toilet Cistern  - White Logo

Related Topics:

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Duravit Home Experts

Paul Carew

Level 3 Expert

2786 Answers

Lawrence Oravetz

Level 3 Expert

9845 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

16646 Answers

Are you a Duravit Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...