- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
HY ACORDING TO THE MANUAL YOU SHOULD TURN THE IGNITION ON SWITHCH THE RADIO OFF PRESS THE AS BUTTON WHILE YOU TURN THE RADIO ON,AFTER 5 SECONDS YOU SHOULD HER A BEEP AND ON DISPLAY YOU CAN SEE 10SAFE AFTER 5 MORE SECONDS YOU SHOULD BE ABLE TO ENTER YOUR CODE USING FIRST FOUR BUTTONS FOR 0-YOU PRESS ONCE AND SO ON WITH THE OTHER DIGITS.
does your radio ask for the code when you turn on the ignition key. If you see _ _ _ _ or **** you should enter the code using the pre set numbers for your radio, ie, first code should be entered using the first pre set key on the radio ( number one ).
Followed by the second code number being entered using the second pre set button and so on until all of the code is entered.
After entering the full code the radio should accept, if not enter code again and press the next pre set key following, ie, if the code is 4 digits, press the fifth.
Hope this works.
If all this fails most garages will set the security code for you for a small charge. Make sure you take proof of car ownership otherwise they will normally refuse to reset the code. This is to foil theft.
Your radio will require one of the following procedures.
Type 1 During the code request mode, while holding the DISP key depressed, press and hold the Volume UP or DOWN key for 3 seconds (so that “…” disappears). Then using your remote enter your code.
Type 2 Press the "Auto" button and "Track up" on face of radio at the same time. The four dash lines ( . . . . ) should "disappear".
Then using your remote enter your code.
Type 3 Model# DPX-4020 and DPX-4030 Press and hold the 1 then the 6 preset key (preset keys are the buttons on face of radio for storing you "favorite" radio stations). "C" should display. Then using your remote, enter your code.
Enter your number from the remote control unit. Your code number is 5227 (KCAR)
* Press numeric key “5” ( 2 times ) and press the Track UP/Next Track key * Press numeric key “2” ( 3 times ) and press the Track UP/Next Track key * Press numeric key “2” ( 1 time ) and press the Track UP/Next Track key * Press numeric key “7” ( 2 times ) and press the Track UP/Next Track key
The security is canceled and the set enters the TUNER mode!