My HDTV seems to be very Low Def - Panasonic Projection PT47WX54J

You have an issue with the convergence board possibly a blown transistor in the blue control or the defaults for the auto convergence needs to be reset.

The convergence ICs have failed. You will need to install a convergence repair kit. You can get the convergence repair kit for your model Panasonic from www.tvrepairworld.com which contains both of the Convergence ICs , the associated resistors and the cD with detailed repair instructions.

Adjust the convergence or reset it to factory default. Use only the remote when adjusting convergence. The front controls have no effect.

1. Press action button to enter MENU.
2. Navigate to SETUP.
3. Scroll down to CONVERGE.
4. Press VOL > to select.
5. Press CH buttons to navigate up or down.
6. Choose CONVERGENCE ADJ or RESET TO DEFAULT.
7. Press VOL > to select.
8. If CONVERGENCE ADJ is selected the align Green to Center screen will be displayed.
9. Use the navigation buttons on the remote control to align the horizontal and vertical green lines on screen, with the cabinet reference marks on top center and left
   center of cabinet.
10. Press ACTION button to display red center correction screen.
11. Use the navigation buttons on the remote control to align the red cross with the white cross pattern at the center of the screen. To prevent picture tube damage do not leave test pattern on for an extended period of time.
12. Press “0” on the remote control keypad to display the BLUE center correction screen, repeat procedure for adjusting blue. If needed press “0” again to return to RED correction screen. An adjusted cross pattern appears white with a minimum of color protrusion.

NINE POINT CONVERGENCE CORRECTION
Remote Control must be in TV mode.

1. Press ACTION button to display red correction screen.
2. Press the 1 through 9 keypad buttons on the remote control to select the desired convergence position.
3. Use the navigation buttons to align the RED cross with the white cross pattern.
4. Press “0” on the remote control keypad to display the BLUE correction screen, then repeat procedure.
5. To exit press ACTION button repeatedly, then press CH up.
   
6. 
   

1. 
   

you need to go to your remote, look up menu. then select "convergence"...this will give you a "crosshairs pattern to align your "guns" ...it has three red, blue, and green.....try not to move the TV around too much....its knocking them out of alignment

Ur convergence is dead.U know how to solder?Tries this website. Tv Repair World.com buy the convergence kit,and replace it.

Replace the two ICs. You can get the convergence repair kit at this link which contains the parts and step by step instructions with pictures.
http://servicemanuals.vstore.ca/product_info.php/pName/panasonic-projection-tv-convergence-repair-kit-2/cName/convergence-repair-kits

never adjust the tubes themselves( No-NO) these are affixed to the chasis in one position and not to be moved. no adjustments should ever be attempted to anything directly attached to the tubes. this will throw off centering, soft-focus, & convergence alignments. it can be corrected but a huge burr on the bottom of the foot! what you have are faulty convergence ic's and maybe sme low-ohm resistors that are bad. repair in-home should not exceed 350.00. parts and labor. mch

you will need to do the convergenace adjustment for each different format then save each setting for each adjustment.

have you ck 2.2 ohm resistors, try looking near ics ck all low ohm resistors.this can cause your problem.

covergence amp ic"S need to be replaced.