Question about RCA TruFlat 27F520T 27" TV

1 Answer

No response i have this tv and it now will not respond to the remote except for the power turns off with it,no on,channels...nothing

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

This sort of fault with a remote is usually due to a build up of muck on the contacts inside under the keys,
Open the remote and lift off the rubber key pad and clean the carbon contacts gently with isopropyl alcohol.
once reassembled you should no longer have trouble.
P.S. replace the batteries too!

Posted on Feb 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front panel buttons and remote have stopped working.


Is the favorite channel menu a function that is normally accessed by a button on the remote?

If so, that button on the remote might be stuck.
If this is the case, the menu may at times pop up all by itself and other buttons on the remote and on the TV's front panel may not respond at all (it had happened on my remotes more than once).

Try to clean the remote control (the housing, rubber pad with knobs, circuit board) with ethyl alcohol, when you clean the housing, you should also clean the holes through which the buttons protrude, there might be some dirt that keeps the button stuck.

It may also be a stuck button on the TV front panel, so check these too.

Also, it could be something else, i just wrote the description of a problem and the solution which to me seemed most likely.

Hope you get it fixed.

regards

3rq8 (Triarcuate)

Jul 25, 2009 | Sony FD Trinitron WEGA KV-20FS100 20" TV

1 Answer

Sony kv-36fs16


Maybe the other channels was skip. check it Menu setting under Preset menu. check other channel it should be skip OFF.

Jun 07, 2009 | Sony KV-36FS16 36" TV

1 Answer

Change to channel 3 rather than 2 on Zenith 27" withot a remote


You can use the menu button on the front to autoprogram the unit. Make sure the direct tv is on so the tuner will pick it up. After that, you can program the direct tv remote to operate the tv. The reason the channels won't change is there are none in the memory

Dec 19, 2008 | Zenith C27A24T 27" TV

1 Answer

Toshiba 35a44 problem


check the following power supply components
power transistor of the supply
zener diodes
rectifier diodes

Oct 15, 2008 | Toshiba 35A44 35" TV

2 Answers

Wharfedale LCD3210AF Television- Digital problems!


Well there is still a problem with the TV. I found that by unplugging the power cable that the digital channels worked. But, when I turned the TV on today the problem had returned, I had to take out the power cable again!

Feb 11, 2008 | Standard (CRT) Televisions

1 Answer

Remote problems and now FPA locked


In the worse case:
It is very possible that the remote recieve on the set has gone defective. It is also possible that there is a fault with the processor in the set, and the remote signals are not being responded to.

As for your universal remote, I don't trust them.

Did you try changing the batteries in the remote? Make sure the new ones are actualy in good condition.

Jerry G.

Jan 01, 2008 | RCA 32V420T 32" TV

1 Answer

Remote control not responding


Perhaps you can try what I do when my KV24FV300 runs through channels and will not stop.  Hard to watch and remote will not work.  Nothing works but on and off from set. 

Sony Says:  Take all batteries out of ALL remotes that you use in any way for that set, VCR, etc.  ALL batteries out.  Turn TV off at set.  Unplug TV.  Wait at least 15 minutes then replace all batteries in ALL remotes.  Plug TV back in and turn TV on from set.

Maybe, just maybe it will work.  If it does not work why not call Sony, they always say that cannot happen but they have a solution for it.

niteowl@dejazzd.com

Sep 30, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

Menu wont work, continuos channel search


Usually, this means that something has spilled into the front of the set and has contaminated the pushbuttons. If one of the channel pushbuttons has fluid in it, the set will just sit there searching for channels and will not respond to any other commands. The computer thinks you are pushing the channel button and responds accordingly. When you push another button the computer does nothing because it thinks that you are pressing 2 buttons at the same time. The board should be cleaned and any contaminated pushbuttons replaced by a qualified tech.

Aug 23, 2007 | RCA F36715 36" TV

1 Answer

TV suddenly doesn't respond to Sony remote & power button on Satellite remote.


I am having the same problem with the "initial setup" screen flashing repeatedly/ intermittently. It's not a problem with the remote. In the research I have done online, it seems as though this is a common/known problem with the Wegas that will require a service visit. Apparently the problem is a defective receiver chip. The best thread I found is at: http://www.agoraquest.com/viewtopic.php?topic=15393&forum=34&start=0&select_page_number=1 I've seen some speculation that it is caused by windex or cleaning fluid dripping down when the screen is cleaned and corroding one of the internal components. That's not applicable in my case, since I always just clean the screen with a microfiber dusting cloth. So, I guess I will be calling a repairman and spending $$$ to fix as it is now flashing up so often as to be unwatchable. Ridiculous, I think, given that my TV is only 3 years old!!

Jan 09, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

Not finding what you are looking for?
RCA TruFlat  27F520T 27" TV Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68157 Answers

John mullen

Level 2 Expert

245 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a RCA Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...